Outside-mount nozzles
I Fail....
07-14-2009, 09:06 PM
#23
Elite Member
iTrader: (1)
Join Date: May 2009
Location: Jacksonville, FL
Posts: 5,155
Total Cats: 406
Now that I look at the designs of these dry nitrous nozzles I see that they probably wouldnt atomize water very well, so they would have to be used with a high pressure pump or in a direct port configuration I suppose.
I was thinking of doing a direct port setup with nitrous nozzles, I already have some NX distribution blocks and a NX solenoid, so I think i could make it work without much trouble.
I was thinking of doing a direct port setup with nitrous nozzles, I already have some NX distribution blocks and a NX solenoid, so I think i could make it work without much trouble.
Reply
0
0
07-15-2009, 10:04 AM
#25
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
Now that I look at the designs of these dry nitrous nozzles I see that they probably wouldnt atomize water very well, so they would have to be used with a high pressure pump or in a direct port configuration I suppose.
I was thinking of doing a direct port setup with nitrous nozzles, I already have some NX distribution blocks and a NX solenoid, so I think i could make it work without much trouble.
I was thinking of doing a direct port setup with nitrous nozzles, I already have some NX distribution blocks and a NX solenoid, so I think i could make it work without much trouble.
Reply
0
0
07-15-2009, 11:26 AM
#26
Elite Member
iTrader: (1)
Join Date: May 2009
Location: Jacksonville, FL
Posts: 5,155
Total Cats: 406
well you would be putting small jets in them, s they wouldnt release any more water than the normal WI nozzles, but yah, i dont think they would atomize worth a damn
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
