1.8 Bottom mount turbo setup
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2011
Location: Albuquerque, NM
Posts: 380
Total Cats: -14
1.8 Bottom mount turbo setup
1.8 bottom mount turbo setup
I was told the turbo was a gt2560r but I don't know if it is or not.
Turbo
Manifold
Turbo elbow
Braided oil lines
Hoses for water lines
Engine, clutch and all other parts have been sold already.
$660 OBO shipped
Email: the80h@yahoo.com
I was told the turbo was a gt2560r but I don't know if it is or not.
Turbo
Manifold
Turbo elbow
Braided oil lines
Hoses for water lines
Engine, clutch and all other parts have been sold already.
$660 OBO shipped
Email: the80h@yahoo.com
Last edited by Dot3; 07-16-2014 at 11:29 PM.
#11
How's the shaft play? Internal housing coated with oil? Also you have the heat shield to go along with it? Did you lose power steering and ac? Couldn't find much info on the avo 1.8 kit. Just the 1.6.
#12
Junior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2011
Location: Albuquerque, NM
Posts: 380
Total Cats: -14
Very very little side to side, and maybe a 1mm in and out. I don't see any oil in the turbo. I think I threw out the heat shield. If I find it it will come with it. I think it hits the ps and AC. But now I remembered the only reason I didn't run AC is because my oil drain was hitting the AC bracket. Also ps was removed to do a de powered rack. So I never really fit the setup with ps or AC. I think it was very close to ps but I don't remember.
Thread
Thread Starter
Forum
Replies
Last Post
FAB
Prefabbed Turbo Kits
216
03-22-2017 04:00 PM