Output Test mode - Idle Valve
#1
Output Test mode - Idle Valve
hi guys my Idle valve seems to be working in reverse? When i went to the output test mode- idle valve when i clicked enable test run and set it to 0 my rpms went from 1100 to 3000, this is with the valve mode in "Normal, 0% = off" shouldnt my rpm stay the same? and only go up when i reach a certain number? (ie 26). Im following this guide to help me set up my idle: Mega Miata: Basic idle settings. and vise versa with the valve mode on "invert" where 100% = off. im trying to get my min/ max pwm % so i can set up the CL idle. Thanks guys!! my car is running a mspnp2 na 1.6 miata.
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,508
Total Cats: 4,080
no. The way the idle valve rotates it can open back up under a certain value.
you're going to find you'll be running your valve between 25-60% PWM.
values outside that range will just cause the valve to open 100%.
you're going to find you'll be running your valve between 25-60% PWM.
values outside that range will just cause the valve to open 100%.
#4
Hey, I am also have trouble in idle.
I am sitting at about 600 when my NA likes 850. We know that it's running rich, seeing as how the AFR is at about 11-12.3. I've adjusted the AFR and VE tables, but to no avail. I saw that maybe it might be Accel Enrich issues, but I can't figure it out. How do you adjust the idle position?
I am sitting at about 600 when my NA likes 850. We know that it's running rich, seeing as how the AFR is at about 11-12.3. I've adjusted the AFR and VE tables, but to no avail. I saw that maybe it might be Accel Enrich issues, but I can't figure it out. How do you adjust the idle position?
Thread
Thread Starter
Forum
Replies
Last Post