Motion Control Single adjustables installed
#42
My single adjustable setup (KH Motorsport using improved TTX parts) works wonders compared to many others but it's now sold for $3+k (sans tax). You gotta pay for someones time.
But which of the well designed offerings is the fastest for you? Get one of each setup and compare yourself.
Even if there were a spec series with open shock/springs you would not be able to judge from the outside since there are too many other variables. The tool holding the wrench plays a bigger role than the wrench itself.
#47
Senior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2011
Location: Beaverton, OR
Posts: 771
Total Cats: 39
A quick video of me chasing my friend George around Oregon Raceway Park clockwise. He was in his evo IX on Ohlins doubles, Dunlop z2s, bolt ons, and tune, puts down around 330 wheel or so.
https://www.youtube.com/watch?v=-HpK...ature=youtu.be
https://www.youtube.com/watch?v=-HpK...ature=youtu.be
#50
Elite Member
iTrader: (2)
Join Date: May 2008
Location: Portland, Oregon
Posts: 3,468
Total Cats: 365
Laz went under 2 minutes with Eddie Nakato driving. IIRC Martin managed a 2 flat towards the end. I had a 2:01.7 mid-day, later I managed a 2:02.1 with my student in the car.
Our cars are pretty evenly matched, it was good times chasing each other. My 600lb penalty compared to Laz hurts
Our cars are pretty evenly matched, it was good times chasing each other. My 600lb penalty compared to Laz hurts
#51
Senior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2011
Location: Beaverton, OR
Posts: 771
Total Cats: 39
I finished the day with a 1:59.8 with me driving. Eddie took the car to a 1:59.2 with me riding passenger. Car has more left in it but my exhaust was leaking more and more as the day progressed and eventually the whole rear of the muffler flew off, car felt super down on power by the end of the day.
#53
Senior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2011
Location: Beaverton, OR
Posts: 771
Total Cats: 39
Yeah, I was on SM6 takeoffs, I know for a fact the car has 1-2 seconds in it at least in the current configuration. The big limiting factor at this point is the flacid 235K chassis. I dont have the means to cage the car yet so we are going to do some door bars for it.
As far as the exhaust I think the new packing is working, we just need to actually weld it together instead of using rivets. Car was losing power throughout the day as the exhaust leaked more and more.
Ideally the car will have the VVT motor in before then but I'd like to get it below 1:30 around PIR on the 1.6 before then.
As far as the exhaust I think the new packing is working, we just need to actually weld it together instead of using rivets. Car was losing power throughout the day as the exhaust leaked more and more.
Ideally the car will have the VVT motor in before then but I'd like to get it below 1:30 around PIR on the 1.6 before then.
#59
Senior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2011
Location: Beaverton, OR
Posts: 771
Total Cats: 39
^here is a thread for you then, we just installed a set on a local NC and he is very pleased with them. PM me if you have more questions.
Adrenaline Racing & MCS - MX-5 Miata Forum
Adrenaline Racing & MCS - MX-5 Miata Forum