2.0...ish build
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2016
Location: Utah
Posts: 109
Total Cats: -30
2.0...ish build
Since my car doesn't even have 200whp, I decided to build an engine swap out with my current stock motor once it is built, and keep the same cooling and turbo setup. KEEP IN MIND...I was raised under power lines on a strict diet of paint chips so if it ever gets retarded you will know why.
I'm sure the question to the effect of "why don't you swap it with 50 gajillion times better motor if you are going to spend that kind of money," the answer is simple, I still want the motor to look like a stock miata engine.
95 bp block bored out to 84mm
Supertech 84mm 8.6:1 pistons
Wiseco 84mm rings (I read on a forum once the Wiseco Rings work better)
Manley connecting rods
OE Crankshaft
Boundary Engineering oil pump
ACL bearings
ATI Dampner
The Head
Stock 94-97 head, polished and ported,
Cams are still very debatable, I was just going to put some OE cams and let megasquirt offset the timing but if anybody has any recommendations that a tried and tested not browsed and googled I'd be willing.
+1mm supertech valves
supertech valve springs
polished and ported OE intake manifold
Skunk2 throttle.
I'm sure the question to the effect of "why don't you swap it with 50 gajillion times better motor if you are going to spend that kind of money," the answer is simple, I still want the motor to look like a stock miata engine.
95 bp block bored out to 84mm
Supertech 84mm 8.6:1 pistons
Wiseco 84mm rings (I read on a forum once the Wiseco Rings work better)
Manley connecting rods
OE Crankshaft
Boundary Engineering oil pump
ACL bearings
ATI Dampner
The Head
Stock 94-97 head, polished and ported,
Cams are still very debatable, I was just going to put some OE cams and let megasquirt offset the timing but if anybody has any recommendations that a tried and tested not browsed and googled I'd be willing.
+1mm supertech valves
supertech valve springs
polished and ported OE intake manifold
Skunk2 throttle.
#9
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jan 2016
Location: Utah
Posts: 109
Total Cats: -30
So...here is a question...one of the types that will pull my intelligence into question...How hard is it to set triggering/wire the triggering to work with my ms2pnp? Is this even an option or would I have to get a new engine management system (ms3 or the 99-00ms)?
#12
So...here is a question...one of the types that will pull my intelligence into question...How hard is it to set triggering/wire the triggering to work with my ms2pnp? Is this even an option or would I have to get a new engine management system (ms3 or the 99-00ms)?
this one definitely does
Thread
Thread Starter
Forum
Replies
Last Post