Stupid question, but a search brought up nothing- Polyurethane bushing question
Thread Starter
Elite Member
iTrader: (12)
Joined: Apr 2008
Posts: 2,712
Total Cats: 25
From: Springfield IL
Stupid question, but a search brought up nothing- Polyurethane bushing question
With Polyurethane bushings, or any suspension bushing in general (On the A-arms), do the eccentric bolts "crush" the metal sleeve, leaving the polyurethane bushing to spin around the sleeve?
The reason I ask- the previous owner installed a set of these bushings on the car and they are VERY stiff, and squeak constantly (only worried about them being hard to move, could care less about squeeking) . I'm thinking about putting Zerk fittings in the A-arms to allow a quick and simple greasing so the suspension can do its job correctly again.
Any insight?
*EDIT*
More Google searching brought Emilio at 949racing to the rescue!
Installing Zerk fittings
The reason I ask- the previous owner installed a set of these bushings on the car and they are VERY stiff, and squeak constantly (only worried about them being hard to move, could care less about squeeking) . I'm thinking about putting Zerk fittings in the A-arms to allow a quick and simple greasing so the suspension can do its job correctly again.
Any insight?
*EDIT*
More Google searching brought Emilio at 949racing to the rescue!
Installing Zerk fittings
Reply
0
0
Senior Member
Joined: May 2007
Posts: 997
Total Cats: 156
From: Atlanta
I've been zerking my install. The center metal bushing rotates, the poly parts are static.
Installing Zerk fittings
Installing Zerk fittings
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
