quick important question!
#1
quick important question!
i just finish the turbo set up on the car and getting ready to start it. im running ms/extra parallel with stock ecu. prob is im running gm air temp and water temp sensors and i got the map vac line i got to run threw the fire wall and im not seeing any ware to pass them threw. i mean the engine harness passes threw but its all the way behind the blower and looks impossible. any ideas? i would ready appreciate the help trying to get my car on the road.
#2
Elite Member
iTrader: (11)
Join Date: Jun 2007
Location: Overland Park, Kansas
Posts: 5,360
Total Cats: 43
Where the engine harness goes into the car on passenger side.. its *NOT* easy but I have fished several vacuum lines through there before. I poked a small hole in teh rubber boot with a coat hanger and fished it out from inside. Tape your line to the hanger and carefully pull it through. Its a PITFA though.
Thread
Thread Starter
Forum
Replies
Last Post
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM