Follow up on 2-toothed nb crank trigger
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2006
Location: N/A
Posts: 359
Total Cats: 0
Follow up on 2-toothed nb crank trigger
I know cjernigan was interested and for any other standalone nbers; I've been running my 99 with the stock crank/cam sensors but a 2-toothed crank wheel for a bit over a month now with absolutely 0 problems. So for any of you using the ms-1 standalone and want to get rid of the cas this is perfect.
To set it up:
1 Use DIY's input/output mods
2 From the ecu side of the wiring harness run CKP (Pin 2J, GRY/Red) to pin 24 on the ms and run CMP (Pin 2H, GRY,BLU) to pin 25 on the ms.
3 On the trigger wheel behind the crank pulley carefully grind off the two teeth marked as being for TDC.
4 Use the same megatune settings as the CAS but change the trigger angle to 73*. (yes i know its wrong in my drawing)
5 Profit
To set it up:
1 Use DIY's input/output mods
2 From the ecu side of the wiring harness run CKP (Pin 2J, GRY/Red) to pin 24 on the ms and run CMP (Pin 2H, GRY,BLU) to pin 25 on the ms.
3 On the trigger wheel behind the crank pulley carefully grind off the two teeth marked as being for TDC.
4 Use the same megatune settings as the CAS but change the trigger angle to 73*. (yes i know its wrong in my drawing)
5 Profit
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM