Car: bone stock '91, no a/c. no IAT setup, narrowband sensor.
Megasquirt: MS1 v2.2, spark mod, cas mod, .1 uf capacitor installed
Firmware: MSnSe 029y4. successfully loaded up firmware.
Software: Megatune 2.25 p3, communication with ecu successful.
Basemap: MSPNP9093 msq file.
Readings during ON and while cranking:
~80-90 Kpa engine map
~23 deg. F coolant temp
no manifold air temp (no iat installed)
0 pulse width
0% Duty Cycle 1
10 deg. BTDC
From reading all of the stickies and diyautotune's directions I assumed that loading up the firmware and getting a decent basemap installed would allow me to fire up the car without adjusting too many other settings.
I guess I should start with getting an RPM reading going?
Thanks for all your support.
pics of my build and a short movie are here:
Index of /seoulracer/megasquirt