1.6 ECU pin 1U - Dimmer for MTX-L?
#22
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
omfg dude. read the manual that came with your WBo2.
does it say anywhere that you should twist together output 1 and output 2 and send two separate programmable outputs to the same single place?
you bumped a nearly 1 year old thread to ask a silly unrelated question that shouldn't be legitimized with a serious response.
does it say anywhere that you should twist together output 1 and output 2 and send two separate programmable outputs to the same single place?
you bumped a nearly 1 year old thread to ask a silly unrelated question that shouldn't be legitimized with a serious response.
#23
omfg dude. read the manual that came with your WBo2.
does it say anywhere that you should twist together output 1 and output 2 and send two separate programmable outputs to the same single place?
you bumped a nearly 1 year old thread to ask a silly unrelated question that shouldn't be legitimized with a serious response.
does it say anywhere that you should twist together output 1 and output 2 and send two separate programmable outputs to the same single place?
you bumped a nearly 1 year old thread to ask a silly unrelated question that shouldn't be legitimized with a serious response.
So I will only be using one of the outputs for my DIYPNP then? Is it just the yellow one and make sure it goes into the pin of the DB-15 connector that is jumpers to 02 on the board?
I appreciate your time
#31
If the yellow wire transmits 7.35 to 22.39 AFR, and you want 7.35 to 22.39 AFR transmitted, i would suggest using the yellow wire, because it transmits 7.35 to 22.39 AFR.
The appropriate place on your DIYPNP would be the place where a wideband o2 input is supposed to go.
The appropriate place on your DIYPNP would be the place where a wideband o2 input is supposed to go.
Can you either tell me or direct me to a source that can tell me where on the board that this signal needs to go to?
Thread
Thread Starter
Forum
Replies
Last Post
chitty chitty bang bang
MEGAsquirt
3
12-02-2013 02:48 PM