Can I run with no o2 ?
#23
Bryan, you need a firmware update on your LC-1. I've not had any issues since I got rid of the Ver. 1.10 firmware. I've posted all the LC-1 firmwares here (see post #68):
https://www.miataturbo.net/showthrea...t=55737&page=4
https://www.miataturbo.net/showthrea...t=55737&page=4
#24
Junior Member
Thread Starter
Join Date: Oct 2008
Location: Mechanicsville va
Posts: 91
Total Cats: 0
I also will look into the firmware.
I picked up the car this morning and made the 115ish mile drive back to richmond. With having a new clutch it in (yes i know not the best idea to put a new clutch it in with no break in) I was not able to really roll through the gears. I did do some 3/4 throttle pulls on the interstate and it was quite fun. I would say it felt about the same as my speed3 did.
When I got to the shop the car had not been started today. It turned right over and idled with 0 problems. the idle was a little higher than i expected but settled down and was very smooth. The car really drives like it did before I started the work.. if not a little smoother.
I was very very worried about it but I think it is good and I am very happy with the service I got.
I will post the maps later today and dyno sheet.
have to get to work now.
I picked up the car this morning and made the 115ish mile drive back to richmond. With having a new clutch it in (yes i know not the best idea to put a new clutch it in with no break in) I was not able to really roll through the gears. I did do some 3/4 throttle pulls on the interstate and it was quite fun. I would say it felt about the same as my speed3 did.
When I got to the shop the car had not been started today. It turned right over and idled with 0 problems. the idle was a little higher than i expected but settled down and was very smooth. The car really drives like it did before I started the work.. if not a little smoother.
I was very very worried about it but I think it is good and I am very happy with the service I got.
I will post the maps later today and dyno sheet.
have to get to work now.
#25
Elite Member
iTrader: (14)
Join Date: Sep 2009
Location: Birmingham, AL
Posts: 2,101
Total Cats: 180
Bryan, you need a firmware update on your LC-1. I've not had any issues since I got rid of the Ver. 1.10 firmware. I've posted all the LC-1 firmwares here (see post #68):
https://www.miataturbo.net/showthrea...t=55737&page=4
https://www.miataturbo.net/showthrea...t=55737&page=4
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM