CAS + 12+1 crank wheel?
#1
Elite Member
Thread Starter
iTrader: (1)
Join Date: Jun 2012
Location: NH
Posts: 9,479
Total Cats: 104
CAS + 12+1 crank wheel?
Ok. Trying to setup another dudes EMS4 which I told him not to buy because its a piece of ****, but besides that. I get there and find out he put on a 949 crank pulley and 12+1 wheel with an NB crank sensor and is using the cam signal from the CAS (un modded, is there something that happens in there when you do this ****? I normally just throw CAS's away). Anyways I cant get it to start sync and it just gives timing and sync errors. I tried both using the AEM stupid wizard thing and then also trying to use the settings out of my car with the 01+ cam trigger. I think I've narrowed it down to either the CAS mod thingy I keep seeing mentioned when I search and having the sync offset wrong.
TLDR
94 chassis
EMS4 with boomslang harness
CAS with only the cam signal wire hooked up
99+ Crank sensor with 12+1 wheel
No start sync
no composite logs because AEM has teh gays and doesnt do that stuff
TLDR
94 chassis
EMS4 with boomslang harness
CAS with only the cam signal wire hooked up
99+ Crank sensor with 12+1 wheel
No start sync
no composite logs because AEM has teh gays and doesnt do that stuff
#3
Soviet did it here. I haven't been able to find much in the way of information on the mod other than that.
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM