hell freezes over: hustler's progress thread
#24
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
I can get it road tuned in a few hours, and hopefully electronic boost control will work. Once I get it running, I just have to get it on a dyno and I have 2 places in mind...then I can probably franticly call BEGi and drive down there for tuning.
#34
re: coolant route
Since you're running MS you can use the fan thermo switch port/bung as your heater core source. Just overbore and rethread - did the same on my FE. Then just put a port on the reroute pipe that runs from the back of the head the rad. This is similar to what brgTom did with his- drilled a new hole pre tstat and threaded it.
Since you're running MS you can use the fan thermo switch port/bung as your heater core source. Just overbore and rethread - did the same on my FE. Then just put a port on the reroute pipe that runs from the back of the head the rad. This is similar to what brgTom did with his- drilled a new hole pre tstat and threaded it.
#36
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
I may get pulled down to San Antonio in a couple weeks on a priority assignment. Now I just have to get home, piece the car together, then drive it to BEGi for tuning...if I end up going. I can't seem to get a break on work.
#37
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
re: coolant route
Since you're running MS you can use the fan thermo switch port/bung as your heater core source. Just overbore and rethread - did the same on my FE. Then just put a port on the reroute pipe that runs from the back of the head the rad. This is similar to what brgTom did with his- drilled a new hole pre tstat and threaded it.
Since you're running MS you can use the fan thermo switch port/bung as your heater core source. Just overbore and rethread - did the same on my FE. Then just put a port on the reroute pipe that runs from the back of the head the rad. This is similar to what brgTom did with his- drilled a new hole pre tstat and threaded it.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM