vehicular

iTrader: (3)

I don't like this game. It's discouraging.

hustler

iTrader: (6)

Bolt in the VVT engine, 6-speed, and build the rear end for my daily.

Braineack

iTrader: (62)

kill gremlin.

9671111

iTrader: (10)

*

RedCarmel

iTrader: (7)

Fuel filter
Install oil pressure sending unit and gauge from a 1.6
Fix tension cable in the top
Timing belt/water pump change
Wash/clay bar/wax exterior
Boost

rleete

iTrader: (21)

Remove downpipe, weld in wideband bung, reinstall. Put MsPnP back in.

RyanRaduechel

iTrader: (10)

I have made some progress.

Oscar

iTrader: (2)

-Simplify/redo/rewrap wiring loom
-Get MS3X
-P&P/build/install 99 head w/01 manifold
-Tune
-Heatshield header/footwell area
-Install heater/defogger for windshield
-Install diff temp sender/gauge
-Install bushings in control arms/swaybars
-Get bigger front sway
-Install NB rear topmounts
-Install Aerocatch pins on hood
-Lose ~50lbs
-Align/corner weight
-Learn to drive

pusha

iTrader: (5)

this is just off the top of my head:

aluminum radiator
radiator ducting
oil cooler
sandwich plate
oil temp gauge
oil pressure gauge
coolant temp gauge
exhaust manifold gasket
install header
install the rest of the exhaust system
new suspension bushings
upgrade sways
turn boring msm shocks into coilovers
source NB tophats
install suspension
new steering wheel
change all fluids
replace pads
replace rotors
replace all ball joints or just the boots, idk yet
fab up gauge cluster
strip wiring harness some more
get alignment done

2ndGearRubber

Rear main seal/Trans seals
Put in the clutch/maybe a lightweight flywheel
EBC Red stuff brake pads
Paint calipers
949 endlinks for the rear bar
Mazdaspeed motor mounts
Fix wobbly air box
Buy new glove box
Repaint valve cover
Buy new drivers seat due to small, but annoying, tear
Continue to battle rocker rust
Continue to lose
Be forced to buy new 99 Miata

skidude

iTrader: (3)

My updated list:

- Get resonator welded into exhaust and install exhaustThese plans changed
- Create intake with recirc BOV fitting Still need to paint it, but it works.
- Alignment sort of done
. Wash/Wax
- New tires Should be done today or tomorrow
- Tune cold-start Will probably never be done
- Dyno
- Drive car.
- Install new ARTech exhaust, once it arrives

I changed the plans for a quiet exhaust. I also did an alignment myself, but I think the caster is way off, and I don't trust it, so I plan to get a real alignment done in the next couple weeks.

sstony

Dyno this car and car A/F
Megasquirt to replace band aids then tune on loaded dyno
Learn more about turbo systems and the set up on my car
Replace high psi ac line and recharge R12
Alignment
Paint hardtop black
Timing belt and front seals
Relocate and reinstall cruise control acuator
Swap SS brake lines from my aborted car
Replace brake pads and fluid
Service trans and diff fluid
Replace plastic bezel around steering wheel
Replace cracked dash pad
Buff oxidation from paint
Upgrade headlights to Bosch
Try my hardest to keep this car as clean as previous owner.


Wow I didn't realize I had so much to do with it. By looking at the list you'd think my car was POS when in fact it's quite nice and cleaner than my previous 2 NA's

Way down the line: pull and go through motor and turbo from my aborted car for future swap into current ride.

Thanks for this thread. Really put the whole picture in perspective.