All I got was an email asking me to confirm my shipping address, which I did. No tracking number yet.

Is this the FedEx one from Bill at Miataroadster? Then Yes.

That's the one!

PM sent with your tracking number.

Got it, thanks Rev!

Mine just arrived! Now it's time to get to work!

I'm so jealous.

Moar ECUs delivered. :)

Instructions for my unit?

missed my delivery, also found out my doorbell is broken, even worse i have a pbx based doorbell... repair costs FTL

Emails sent out with instructions and the required .ini file. If anyone is missing it, let me know.

https://www.miataturbo.net/attachmen...ine=1324736907

Could you tell me what these 5 wires are for? 90 to 93 1.6 harness

Step 34 in the instructions I sent you:

a) Yellow - Wideband input. Connect this to your wideband analog output
b) Grey - Switchable tables. Connect this to a ground (through an on/off
switch) to switch between VE/Ignition tables.
c) Brown - Launch control. Connect this to a ground (through an on/off switch)
to switch launch control on/off.
d) Violet (purple) - Boost control low/high. Connect this to a ground
(through an on/off switch) to switch between low/high boost tables.
e) Green - Boost control output. Connect this to a boost control valve. The
other wire of the boost control valve needs to be connected to a switched and
fused 12V source. A 5A fuse is recommended.

My mistake.... also what is it going to take to run sequential?

You will need to convert your engine (injector) harness to sequential first. I would advise that you first get the car up and running as-is, then I can you give complete instructions on how to do it.

Hi Rev,
My unit arrived today. Please send instructions for #10158. Thanks
Happy Holidays



"MAY THE HOLIDAYS BRING YOU JOY AND WONDER,
WHILE YOUR STEERING BE OVER, RATHER THAN UNDER."

For the launch control, would I hook it up to the switch behind the clutch pedal?

I've already sent you the instructions, make sure they are not in a spam folder etc. If not let me know and I'll send them again.

That would work, yes.

As for the COPs, do I still need to put a 1k ohm resistor in the wiring or has the issue been addressed inside the ms2?