just after a confirmation of the parts i need

76pin diypnp
mspnp and diypnp iat sensor kit
ebc kit
innovate mtx-l
usb to serial adaptor.
jimstim

anything i am missing or should really be getting?

i already have spare wire and electronics tools

cheers

 

The JimStim is not 100% necessary, and is actually difficult to use with the DIYPNP. If you create a custom harness, yes you could use it to test the DIYPNP, so there is potential diagnostic functionality there. But you'd actually have to make the harness; it won't just plug in.

The USB2920 cable is only about 2 feet long. You will want a tunecable if you don't already have one (standard DB9, non null modem) or you'll need a USB male to female to act as a "tune cable extension cord".

A 12V power supply is helpful for a quick bench test and firmware loading. There is a standard connector on the board for a 12V 1A power supply. You might have one around your house you can use, or we have one on the site for a few bucks.

Some people opt for the sequential add on. Up to you. It should idle a bit smoother with sequential, especially if you have big injectors.

That's about it.

 

what Ben said.

 

cheers guys thanks for helping.

 

ok all ordered minus the jimstim
cant wait to start making some decent power.