I just completed building a diypnp setup and have been trying for the last 5hrs on how to load the firmware. I followed the instructions and I get the diypnp unit to except the current version of the appropriate firmware in the ms2loader it says it goes 100%.

I then try it in the tuner studio lite version and it identifies the diypnp unit but it shows a box saying this error. I have tried reloading the firmware half dozen times and still the same results. Anyone that can help me I would appreciate it, I was hoping on trying to start my car tomorrow but it looks grim.

Thanks, Bill

 

I won't claim to know exact cause of your issue but thought i'd chuch the DIYAutotune guide link up in case you're working to something else. I did mine fine following this:
DIYPNP Firmware Loading Walkthrough - DIYAutoTune.com

Did you have the Boot Jumper installed?

Dave

 

That's the guide I followed. The link they give for the firmware is the link I clicked and loaded my firmware from. I also have the boot jumper in place. I am frustrated. The usb serial adapter I bought along with the diypnp would not install on my laptop. I had to install it on my wife's laptop and now this damn firmware shows me it's loaded 100% in the ms2loader.

As soon as I get it in the tuner studio and start a new project. It reads it it knows its there but tells me no firmware!! I dunno, thanks Dave for trying.

 

if the boot jumper is still in place then you didn't load firmware or follow the pretty damn clear instructions when flashing.

 

No the boot was off during the flash process

 

I'm have the same thing come up word for word I spent a long time yesterday trying to figure this out on my own but no luck. Please help!

 

loading firmware couldn't be easier.

where are you failing? because if you see "verification sucessful" after watching the firmware load for about 2 minutes, then you shouldn't be seeing "no firmware loaded" once you connect to TS.