DIYPNP First Start Up Issue
#1
DIYPNP First Start Up Issue
Hey all,
I finally got around to cranking over on my DIYPNP. I was stoked to see it idles but its very rough, almost as if its missing. I went to adjust the timing with the trigger wizard and it seems my timing mark on the pulley is jumping back and forth between 10 and 15 degrees BTDC. I did set the timing to fixed in ignition settings for this step as instructed. Any ideas from the MS guru's on here? I have a log and msq attached.
99 Miata
Stock Motor
Naturally Aspirated
440cc Injectors
E85
DIYPNP w/ Sequential Injection
I finally got around to cranking over on my DIYPNP. I was stoked to see it idles but its very rough, almost as if its missing. I went to adjust the timing with the trigger wizard and it seems my timing mark on the pulley is jumping back and forth between 10 and 15 degrees BTDC. I did set the timing to fixed in ignition settings for this step as instructed. Any ideas from the MS guru's on here? I have a log and msq attached.
99 Miata
Stock Motor
Naturally Aspirated
440cc Injectors
E85
DIYPNP w/ Sequential Injection
Last edited by biohzrd53188; 08-11-2013 at 12:24 PM. Reason: MOAR INFOS!
Thread
Thread Starter
Forum
Replies
Last Post