MSP installed and running!
#1
MSP installed and running!
1) Emilio told me that any vacuum 3 inches away from the throttle body was good. So I went with my cruise control plug on the back half of the manifold.
2) Hooked it all up, synced the timing, and fired it up. It was making a howling sound from the intake for the first couple minutes which eventually went away. I'm running the base tune that came with the unit.
3) It seems to have a idle issue. When the idle has settled, it holds around 650rpms, which seems low. When the revs come down it stumbles to like 500rpms and sometimes shuts down. I read about the idle situation and understand adjustments to AFR and timing may be needed. What do you guys think of the following?
AFR
Fuel
ignition
#2
Oh I almost forgot to mention how the MS holds the targeted AFR MUCH better than the stock ecu. When I would look a the wideband with the stock ecu, for example the idle would be constantly moving from 14-15.2. The MS stays within like .3 of the target. Very impressive
It does have some drivability issues and but I'm sure that will be worked out.
It does have some drivability issues and but I'm sure that will be worked out.
#6
Afrs are super rich when on the throttle but it stumbles if Im too aggressive on the throttle and so I'm driving it around like a grandma at this point.
I got the test n tune this Sunday but looks like I'll be mounting the stock ecu next to the ms. Not that I was thinking I'll have it figured out but I waaas hoping I could use the autotune feature but I'm having issues with my wideband.
Thread
Thread Starter
Forum
Replies
Last Post
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM