Sixshooter's Brain-built MS1 Needs to Control WI
#1
Moderator
Thread Starter
iTrader: (12)
Join Date: Nov 2008
Location: Tampa, Florida
Posts: 20,660
Total Cats: 3,011
Sixshooter's Brain-built MS1 Needs to Control WI
Will my Brain-built MS1 control water/meth injection as built or should I rely on some other method of control? I know there are settings for it but I don't know if the unit is built for it.
#2
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Very unlikely.
Even if it is built, the MS1 WI was designed around controlling an aquamist fast acting valve, which is now discontinued.
If you just want it on/off and not progressive your MS1 could likely facilitate this.
Even if it is built, the MS1 WI was designed around controlling an aquamist fast acting valve, which is now discontinued.
If you just want it on/off and not progressive your MS1 could likely facilitate this.
#3
Moderator
Thread Starter
iTrader: (12)
Join Date: Nov 2008
Location: Tampa, Florida
Posts: 20,660
Total Cats: 3,011
I would just like it to come on at 10-12psi. I know how to do that with a pressure switch but was hoping the MS would be able to handle it, since I see the feature listed in the Tunerstudio drop down menu.
#5
Six, I used to run WI on the Silver car with a first generation MSPNP. All I was doing was simple ON-OFF using the MS software. Schematics I used are here: https://www.miataturbo.net/build-thr...e2/#post704609. I basically bread-boarded the add-on circuit and mounted it inside the MSPNP case and brought it out on spare pins.
The problem I ran into was flyback voltage from the relays would sometimes cause MS resets -- even with added flyback diodes. I eventually went to electronic relays ($). Recently, I yanked all my WI stuff when I added an intercooler. If I were to add the WI back, I'd just KISS and use a separate pressure switch I think.
The problem I ran into was flyback voltage from the relays would sometimes cause MS resets -- even with added flyback diodes. I eventually went to electronic relays ($). Recently, I yanked all my WI stuff when I added an intercooler. If I were to add the WI back, I'd just KISS and use a separate pressure switch I think.
Thread
Thread Starter
Forum
Replies
Last Post