Hi Ive got a sync loss error at around 3000 rpm intermittent and some time 5k on throttle I've took a composite log and here's the screenshot

 

Please post the actual CSV file.

 

hi yeah here it is

 

Try turning off all noise filtering.

 

Noise filtering is turned off heres my msq

 

Bump

 

Any chance you've got the actual cam timing off a little?

 

Never touched it was fine before megasquirt

 

Bump still got issues thinking of putting a 10ohm resistor on cam circuit

 

We know youre running an MS2 cpu/firmware, but what exact MS do you have?

 

diy kit from diy auto tune running extra 3.3.3
find enclosed datalog page 96/97 sync loss occurs

 

Do you have ignition input capture set to rising or falling edge?

 

Rising i think if i choose the other it misfires constantly

 

Right so ive just gapped my plugs to .8 they r ngk bkr7e 11 so colder than standard. Also removed crank sensor and cleaned end of metal fillings refit and set gap about a credit card thickness and its still got the problem help me before i take the megasquirt out remove the cam circuit and optoisolator and replace with new parts

 

Also the ecu is wired in parallel with standard ecu sharing the cam and crank input when I wired it in the crank wire white wire is to the crank sensor and the negative black wire is not connected should it be connected? Also thinking about putting a small 5/10 ohm resistor to suppress voltage spikes if its that causing it

 

Right a little update ive just replaced the 2nd opto circuit in the ms2 with new parts and its still the same does seem to drive a bit better tho but maybe placebo effect so its a sync loss around 3k rpm cruising and if im flat out in boost does it about 5krpm with a bang and a flame and a very violent jerk