Tach Signal Suddenly not matching?
02-04-2009, 07:26 PM
#22
Senior Member
Join Date: Apr 2008
Location: NHR, TX
Posts: 538
Total Cats: -2
I'm running a MSPNP on a 92 1.6 with Toyota Cops. I believe my tach was off before I installed the MS. I've had a few issues, but I don't think the MS is the cause. While working on the car I noticed the two bolts that hold the gauge shroud over the steering wheel are gone. The leads me to believe that maybe the previous owner had gauge covers or swapped something. Based on other things I've noticed it wouldn't surprise me at all if the my car once had indiglo gauges .
Ahh the joys of homebrewing. I always wanted one of those propane burners when I was brewing weekly. They make quick work of 5gallons of wort.
As far as the Tach signal, I'm not sure if it was reloading the firmware/msq or playing with my grounds but its working fine again and i'm getting fewer resets. Only had one on my last drive if I recall.
As far as the Tach signal, I'm not sure if it was reloading the firmware/msq or playing with my grounds but its working fine again and i'm getting fewer resets. Only had one on my last drive if I recall.
Reply
0
0
02-05-2009, 12:48 PM
#23
More than a couple people have had issues with inputs - dig around and see if you can find one... You might clean that up. Check your logs, see if there are any jumps to obscenely high or low RPM. If so, there's something you should look at. I generally just look at max/min to see if there's any jumps, spikes to 0 you pretty much have to skim the log.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM
