MS3 Basic Installation Help
#1
MS3 Basic Installation Help
So I'm sure there are like 2 million asking rev for help at any moment of the day. I don't expect immediate responses from him.
The question I have for everyone is, I have a IAT, EBC and want to hook up the LC-1 I have. I have been trying to search though here/Checked his official site, and used google.
I could not turn up anyone talking about this specifically, Idiot proof instructions (what I honestly need)
I mean I know I could just start hooking up wires to the included connector, But If this has a base map on it, I assume that it also means that these wires have pre tuned inputs/ports and MS will be looking for them to be hooked up correctly.
Picture included
I'm just trying to get my car to run/start tonight....
Edited because Idot.
I really want to thank anyone for looking/helping.
Ryan
The question I have for everyone is, I have a IAT, EBC and want to hook up the LC-1 I have. I have been trying to search though here/Checked his official site, and used google.
I could not turn up anyone talking about this specifically, Idiot proof instructions (what I honestly need)
I mean I know I could just start hooking up wires to the included connector, But If this has a base map on it, I assume that it also means that these wires have pre tuned inputs/ports and MS will be looking for them to be hooked up correctly.
Picture included
I'm just trying to get my car to run/start tonight....
Edited because Idot.
I really want to thank anyone for looking/helping.
Ryan
#2
Didn't you get a list for the db37 pinouts with your instructions? If not, shoot rev a message with your ecu serial number. Unless you didn't buy directly from him, try contacting the po.
#3
I purchased it directly from him (Rev). The only thing I got was a Test sheet displaying all of the tests the unit went through to make sure it was good to go. No instructions at all were included.
Serial number is 12242 As im sure Rev will see this or my PM.
So I am correct in thinking that i need instructions to correctly install this bad boy harness? I just wanted to make sure I am not a complete idiot....
Serial number is 12242 As im sure Rev will see this or my PM.
So I am correct in thinking that i need instructions to correctly install this bad boy harness? I just wanted to make sure I am not a complete idiot....
#5
Well damn. I guess I am dead in the water till tomorrow. Thanks for the help anyways guys.
#6
Nvm. Rev Has Risen from the grave of sleep/Outside life to get my instructions to me.
He is a seriously kickass gentleman.
He is a seriously kickass gentleman.
#9
Well its installed. I have a short clip but its rather stupid and just me all giddy since the car has been down for almost 2 months between the turbo install and the subsequent MS purchase.
Edited again. Fixed Idle hunting. Still have that weird noise in video happen at idle.
Edit:
If you notice at 10-14 seconds under my stupid *** voice you can hear the engine.... doing something... What is that, and how do I make it go away?
Edited again. Fixed Idle hunting. Still have that weird noise in video happen at idle.
Edit:
If you notice at 10-14 seconds under my stupid *** voice you can hear the engine.... doing something... What is that, and how do I make it go away?
Last edited by 780racer; 07-01-2014 at 07:00 PM.
#10
Mine does the same!
Did you get to the bottom of it 780?
Did you get to the bottom of it 780?
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM