So I just got done assembling my diy, I installed the firmware and it works on my pc what I'm wondering is if I did the wiring correct (the adapter board) and the jumper cables. Please help and if it is correct can I just plug it in and load there map

 

youre missing the idle fly-back diode and vr and opto pull-up resistors. Bottom right of second shot under NITROUS INPUT


at a quick glance it looks good, I'd personally remove FP from the HIGH SIDE DRIVER and connect it straight to 4O. Then using spare wire, make a small bridge between the 2O pin on the AFM connector and the FP Relay pin.


you need to remove the variable resistor on R19.

 

This is the board without the micro squirt

These are the resistors and diodes I had said

So I will remove the r19 resistor right I was also told to remove the r39 as well where can I find the idle fly back diode spot I have one diode left and it said extra where do I add it to exactly I also have the 3 470ohm resistors for pull ups is that the ones I have to solder onto the vr and opto sports you pointed out

 

God this phot from online is this correct on the resistor and diode

 

im sorry i meant r39, not r19


yes, that's how youll set them up. are you not looking at the how-to documentation on diy's website?

 

Yes. I looked over them that's how I got the connections o was just asking for Someone to double check my connections