Trouble getting car to start on diypnp
08-21-2014, 05:34 PM
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Mar 2008
Location: Navarre, Fl
Posts: 280
Total Cats: 8
Trouble getting car to start on diypnp
I recently finished my diypnp build and got it connected to the car. And can't get the car started. RPMs don't show up on dash or in tunerstudio. Also nothing shows up when i do a composite log. It shows empty read. Nothing shows in tooth, trigger, or sync loss logs either.
Attached my current tune, but i dont think that my tune would cause cam or crank signals to show up. I do have the 470k ohm pull ups installed. And also installed the gm iat sensor and disconnected MAF.
On a side note the car worked just fine with AEM FIC installed and I did removed all the related hardware.
Attached my current tune, but i dont think that my tune would cause cam or crank signals to show up. I do have the 470k ohm pull ups installed. And also installed the gm iat sensor and disconnected MAF.
On a side note the car worked just fine with AEM FIC installed and I did removed all the related hardware.
Last edited by ericsbestshot; 08-21-2014 at 05:57 PM.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM
