Turbo Smurfette - Build in progress (slow)
#981
Elite Member
Thread Starter
iTrader: (4)
Join Date: Mar 2012
Location: Northern VA
Posts: 4,648
Total Cats: 544
wilco. I'll be home @1700. Tighten her up, make a pull or two and bounce back with updates. I'll have 9 hours of time tomorrow to do any conceivable data-logging. I'm just surprised that rod tension would have gone unchecked during shop tuning; it had been mentioned before when discussing the 28psi limit on the dyno.
#983
Elite Member
Thread Starter
iTrader: (4)
Join Date: Mar 2012
Location: Northern VA
Posts: 4,648
Total Cats: 544
I haven't, I just picked the car up on Sunday after having dropped it off May 11.
There was a period of bouncing ideas around, but because it ended up going through a middle person, I didn't often get to speak to Tuan, the tuner. Only for the spark stuff he called directly when I was in San Diego. I've been on several work trips so a lot of time was troubleshooting over phone and here on MT.net. I'm not sure what was done independently outside what I've been told.
There was a period of bouncing ideas around, but because it ended up going through a middle person, I didn't often get to speak to Tuan, the tuner. Only for the spark stuff he called directly when I was in San Diego. I've been on several work trips so a lot of time was troubleshooting over phone and here on MT.net. I'm not sure what was done independently outside what I've been told.