Alternator Control. Dead nailed. MS3 / MS3-Pro / MSPNP-Pro
#49
Edit: gave it another try and tested with JS10 and that didn't work either. Then tried D15 to find out it's used by the knock sensor. Then I gave up. I used a 1K pullup to 5V each try.
Last edited by WestfieldMX5; 06-22-2014 at 03:57 PM.
#52
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Lack of docs is by far the worst thing about MS. There should be at least some documentation before any new feature is made available to the public.
Case in point, there's **** all on the LTFT feature, still.
#54
Why did I leave the board I bought from you at my house at school Frank? Why'd you let me do it? Was hoping I could get things working with this feature to save myself the trip to go get it. But since a lack of a functioning alternator system is the only thing keeping me from tuning, i'm getting annoyed to the point I might have to do just that, or have a roommate ship it. Car is idling great when hooked to a charger to keep the battery going.
#59
Lost pretty much the entire afternoon on it yesterday . Not saying software control doesn't work, just that *I* couldn't get it running, just like the first iteration.
Figured I might as well install my board. 5 mins later, my battery voltage is rock solid to 0.1V precise and I can turn of the alternator at startup as well.
<Shrug and move on>
#60
Supporting Vendor
Thread Starter
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
And the reason I've stopped building them. It's too time consuming trying to find all relevant information in several forums. And even then it's a nightmare.
Edit: gave it another try and tested with JS10 and that didn't work either. Then tried D15 to find out it's used by the knock sensor. Then I gave up. I used a 1K pullup to 5V each try.
Edit: gave it another try and tested with JS10 and that didn't work either. Then tried D15 to find out it's used by the knock sensor. Then I gave up. I used a 1K pullup to 5V each try.
If you wired JS10 to Alt field with a 5V pullup, you're going to have a bad day. That should command the alternator at 100% duty cycle. JS10 might work for field control without a pullup, but I wouldn't try because I don't know how much current the field will sync.
If you add a pullup to JS0, you're going to have a bad day. JS0 switches between 12V and ground. It's a stepper output.
To use either of these pins, you should add additional hardware.
Why not use a spare PWM output with pullup as shown in my posts?