gonna try to install my ms2 on nb
#29
Senior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2009
Location: Royal Palm Beach, FL
Posts: 725
Total Cats: 5
finished installing them, broke a clip for one of the injectors pulling it off but it will stay on. i am using these so i didnt need to cut the harness.
http://cgi.ebay.com/ebaymotors/Supra...Q5fAccessories
Car starts up, idles and drives fine but it has a small hiccup every couple of seconds (during idle). I tried different values for req fuel and drove around with autotune on. tbh, I dont know what to change or look for. I attached my current msq and a msl of my idle. Looking at the diagnostics section I can see the hiccup under exhaust gas oxygen (volts)
http://cgi.ebay.com/ebaymotors/Supra...Q5fAccessories
Car starts up, idles and drives fine but it has a small hiccup every couple of seconds (during idle). I tried different values for req fuel and drove around with autotune on. tbh, I dont know what to change or look for. I attached my current msq and a msl of my idle. Looking at the diagnostics section I can see the hiccup under exhaust gas oxygen (volts)
#34
Senior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2009
Location: Royal Palm Beach, FL
Posts: 725
Total Cats: 5
i thinks its just my afrs not hitting targets. Before when i was on stock jnjectors i was verifying that my afr readings matched the tables and they were always a few .00 off. Spot on id say. Now its at 17.2 when target is 15.3
Last edited by Clos561; 07-12-2011 at 07:43 AM.
#35
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,499
Total Cats: 4,080
but look at your AFRs on that log you posted...here you are saying youre idling at 17.5:1 and we (and your MS) sees you idling at 10.0:1.
you need to enter in the correct calibration for your WB if you are even going to attempt to tune and/or use EGO. Click custom, and enter in the scale that your specific EB outputs.
you need to enter in the correct calibration for your WB if you are even going to attempt to tune and/or use EGO. Click custom, and enter in the scale that your specific EB outputs.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM