iWeasel410

I ordered the DIY kit with the DIY display a couple days ago. It's coming from canada so I should be getting it at the end of this week or next week. I could probably put it together in an hour or so. I'll post up a review of it as soon as I get it.

Arkmage

iTrader: (3)

I might just order one of these myself... I've been wanting the AEM gauge/controller... but this will save me nearly $160. That's considerable enough to be worth the gamble.

neogenesis2004

iTrader: (12)

I have to get one now :( When I swapped out the blown motor for the one Im using until the FE is done I forgot to remove my wideband. The LC1 ended up sitting up against the exhaust for a solid 30minute test drive. Needless to say, I got to see the inside of the device.

steelrat

Neo, what was it you melted, the controller box, or the sensor wire? If it's the sensor, just get a new one from bosch -- VW dealer. Or you can get the box, and use the existing sensor.... <G>

I'm going to order one shortly as well.... probably within the next week or so.

Dave,

neogenesis2004

iTrader: (12)

I melted the complete lambda sensor. It no longer powers up at all.

Braineack

iTrader: (62)

whoops. Innovative just sent me a new one ...but it failed by itself, I didn't need to melt it.


I am thinking about replacing my NB gauge with a lcd panel however, just makes it easier to glance over and see actual numbers and not trying to figure out what LED means what voltage which means what AFR.

Braineack

iTrader: (62)

Ha look at the site again....they have an LCD display now. :gay: after all you guyses bellyachin'...

neogenesis2004

iTrader: (12)

I wonder if thats why lol. Adds alot to the price though :( and the supplied cable is way short.

iWeasel410

I ordered the display kit as well