Finally got a MS3x
#64
I have a soldering iron but not a very steady hand, and I'm over in SC.
I was reading on msextra and DIY said the right leg should be 5v and the left should be 12v.
Megasquirt Support Forum (MSEXTRA) • board voltage wrong (View topic)
3rd post down
I was reading on msextra and DIY said the right leg should be 5v and the left should be 12v.
Megasquirt Support Forum (MSEXTRA) • board voltage wrong (View topic)
3rd post down
#76
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,079
it grounds directly through the oem harness. unplug the vTPS if you didnt figure it out. if wired wrong that will introduce a 5v fault to ground and the MS wont connect and have power just like youre seeing.
#80
Ok so let this rest for a week. I apologize for my stupidity, something so simple.
Anyways, I need to know where on the AFM connector I need to push these two wires in for the GM IAT sensor, and on a MS3x, do I need to worry about the fuel pump not coming on? Or do I need to do something with that circuit as well?
Anyways, I need to know where on the AFM connector I need to push these two wires in for the GM IAT sensor, and on a MS3x, do I need to worry about the fuel pump not coming on? Or do I need to do something with that circuit as well?