Aidan's loose oily bunghole actually runs a track lap
#806
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
I'll post up some more pics in a second. There is a sheet metal box around the actual end tank. I got one corner to work fine, and then drilled too far into the next corner.
#809
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
What do we think about this one:
Setrab Oil Cooler PN 51 07944 An 8 Fittings w Lines and Mount NASCAR Arca | eBay
I looked up the part number and it actually is more efficient than the 19 row I had (and TSE sells). Only issues is where the lines are, but it says its a 2 pass so I think the lines both being on top are ok.
Also, please don't buy it out from underneath me :(.
Setrab Oil Cooler PN 51 07944 An 8 Fittings w Lines and Mount NASCAR Arca | eBay
I looked up the part number and it actually is more efficient than the 19 row I had (and TSE sells). Only issues is where the lines are, but it says its a 2 pass so I think the lines both being on top are ok.
Also, please don't buy it out from underneath me :(.
#812
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Added a 47 ohm resistor inline with the water temp sensor. Brings the values down to match the ECU. Going to do something similar with the oil temp sensor but calibrate it in water when I install the cooler.
#817
What do we think about this one:
Setrab Oil Cooler PN 51 07944 An 8 Fittings w Lines and Mount NASCAR Arca | eBay
I looked up the part number and it actually is more efficient than the 19 row I had (and TSE sells). Only issues is where the lines are, but it says its a 2 pass so I think the lines both being on top are ok.
Also, please don't buy it out from underneath me :(.
Setrab Oil Cooler PN 51 07944 An 8 Fittings w Lines and Mount NASCAR Arca | eBay
I looked up the part number and it actually is more efficient than the 19 row I had (and TSE sells). Only issues is where the lines are, but it says its a 2 pass so I think the lines both being on top are ok.
Also, please don't buy it out from underneath me :(.
#819
Elite Member
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
I believe all the 1.6 IACVs were broken from the factory, were they not?
The Mocal sandwich that we all know and love has 1/2"BSP threaded ports, and a 1/2"BSP to -10 fitting is what pretty much all of us have been using. You can get 1/2"BSP to -8 but there is really no reason to do so when -10 exists.
The Mocal sandwich that we all know and love has 1/2"BSP threaded ports, and a 1/2"BSP to -10 fitting is what pretty much all of us have been using. You can get 1/2"BSP to -8 but there is really no reason to do so when -10 exists.