Jason's reverse Build
Joined: Jun 2006
Posts: 29,085
Total Cats: 375
From: Republic of Dallas
I'm not using the factory mixing manifold, what I do have is a similar smaller piece that started life as the part that Begi sells to rotate that fitting 90 degrees. I don't have any restricter built into the heater core feed at this time. When I put the freeze plug in the front of the engine, I just extended that small line from the oem oil cooler that would normally go there and routed it to prior to the water pump hoping this would help keep temps up a bit.
Reply
0
0
Thread Starter
Elite Member
iTrader: (12)
Joined: May 2007
Posts: 1,881
Total Cats: 2
From: Austin, TX
Hit the local kart track a couple weeks ago to have some fun (enjoyed myself but it's no substitute for a real track, not even close). Andy (Andifer on the forums) stopped by and snapped a few photos during one of the last sessions.
Reply
0
0
Thread Starter
Elite Member
iTrader: (12)
Joined: May 2007
Posts: 1,881
Total Cats: 2
From: Austin, TX
Trying a couple different things with the suspension and part of it was ordering new bump stops. In addition to the bump stops, I got a bag full of goodness in the mail the other day. I could use a little help figuring out where the black bushings and the washers are supposed to go? Perhaps it will be obvious once I pull the coilovers from the car, but I'd rather figure it our ahead of time.
Reply
0
0
I think they squish on top and bottom of the top hat. Are there eight or four of the black disks? Washer goes on top, it should be what the shock shaft's nut clamps down on.
Reply
0
0
This guy might help:
http://www.fatcatmotorsports.com/FCM...structions.pdf
Other pictures/instructions here:
http://www.fatcatmotorsports.com/instructions.htm
http://www.fatcatmotorsports.com/FCM...structions.pdf
Other pictures/instructions here:
http://www.fatcatmotorsports.com/instructions.htm
Reply
0
0
Thread Starter
Elite Member
iTrader: (12)
Joined: May 2007
Posts: 1,881
Total Cats: 2
From: Austin, TX
Not really, this was something that has been part of the plan to get the car ready to sell. I'm hoping to sell/trade it and move on, I've always wanted a Porsche 944 S2 or 968.
Reply
0
0
Thread Starter
Elite Member
iTrader: (12)
Joined: May 2007
Posts: 1,881
Total Cats: 2
From: Austin, TX
Thanks. I've thought about doing the blacked out headlights, but I just can't convince myself to do it until after I paint the front lip.
On a side note, I do have the car listed for sale. It's priced high, but I'm hoping there's someone out there looking for this particular car.
On a side note, I do have the car listed for sale. It's priced high, but I'm hoping there's someone out there looking for this particular car.
Reply
0
0
