http://www.miata.fi/kuvat/2015-05-07-17.42.34.jpg
old Artech manifold & big trim (56) GT2871 with small 0.64 turbine housing. Still enough torque to broke dozen gearboxes

http://www.miata.fi/kuvat/2015-05-07-19.41.jpg
Started porting the .64 housing for quicker wastegate control. Any tips?

http://www.miata.fi/kuvat/2015-05-07-19.40.jpg
I figured oil squirters are pointless with supertech pistons and E85 :jerkit:

Keep smoothing the top of the port inlet like you are doing. Depending on the casting there is only so much you can do here before it becomes too thin

You can open up the outlet side of it a bit, leaving 1.5-2mm of surface to seal against the flapper. That being said if you aren't getting creep I wouldn't bother opening up the outlet.

Thanks.
There is little boost creep if boost limit is set below 15psi. Quicker control what I’m after as we all know 300ftlbs+ is what kill our 6speed’s. EWG would be best but ported IWG with less mid-range ign.timing hopefully do the job and keep my gearbox intact

300ft-lbs limit is ok as long as I can keep that same torque in high revs :skid:

My turbo MX-5
 

sub'd

yo, what you been up to?

bought a dailydriver. had been fixing that

https://www.miataturbo.net/attachmen...ine=1467291524

MY97 STI (JDM import). Running E85 with 1200cc injectors

I love your daily driver

Holy smokes. Yes. Awesome. Moar info plz

Thanks. With DCCD center diff open (65% to rear) handling is really close to Miata. Also weight only 2733 pounds stock.

Engine is stock STI EJ207 except ACL bearings, ARP bolts and Cosworth head gaskets. ECU is modified and tuned by myself. Get 22mpg in highway with E85 :cool: Don't know the exact power figures but it should be over 300hp with IHI VF28 boosting 18PSI with 3" decat

Here's my BP current state :td:

https://www.miataturbo.net/attachmen...ine=1467488187
Had to take engine out due knocking noise from cyl 4

https://www.miataturbo.net/attachmen...ine=1467488187

https://www.miataturbo.net/attachmen...ine=1467488187
wtf?? Supertech piston had broken around the pin allowing pin to slide out....

https://www.miataturbo.net/attachmen...ine=1467488187
...and broken in half :eek5: whyy? :vash: