Nothing to see here, just project Sisyphus, move along
#2421
Elite Member
Thread Starter
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
Well I certainly have that. What exactly does it use for gear detection and how well does it work? Do you currently have it set up?
#2422
SADFab Destructive Testing Engineer
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
It uses VSS and it works perfectly. I run like 8psi in second, and barely lose traction up top. Then full boost in 3rd and up because peasant torque.
I just realized I might need to adjust my pulse per mile because different rear end ratio. Hmmm.
I just realized I might need to adjust my pulse per mile because different rear end ratio. Hmmm.
#2426
Elite Member
Thread Starter
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
Yeah, that's what I'm afraid of. I think one of my biggest failures thus far was not getting the car running on 1.4.0 before bringing it to you. Now I'm scared to death to try to update the firmware.
#2438
Elite Member
iTrader: (3)
Join Date: Apr 2014
Location: Huntington, Indiana
Posts: 2,885
Total Cats: 616
You only need the upright for the sensor mounts.
The only difference in the axles is the ring, which just presses on. I don't think the axles are different otherwise.
Lemme take some pics.
The only difference in the axles is the ring, which just presses on. I don't think the axles are different otherwise.
Lemme take some pics.