Pictures of my rod for Hustler
Joined: Jun 2006
Posts: 29,085
Total Cats: 375
From: Republic of Dallas
How about nixing the turn buckle all together and actually making it with a cable. Since this should only ever be loaded in tension you can use the cable as the 3rd member You'll just have to give its own support that sticks up randomly and close to the hood. Then if for some reason your manifold shape naturally moved upwards on heating it could.
Note this requires a cable with good high temp heat properties like 321 stainless or 316Ti, I'd worry about carbon steel failing from corrosion in a very short time since it has a high surface area to volume ratio and is going to be somewhere hot.
Note this requires a cable with good high temp heat properties like 321 stainless or 316Ti, I'd worry about carbon steel failing from corrosion in a very short time since it has a high surface area to volume ratio and is going to be somewhere hot.
Reply
0
0
Thread Starter
Joined: Oct 2005
Posts: 15,198
Total Cats: 1,398
From: Oregon City, OR
Real question:
Make the triangle symmetrical like Tim's picture, or center it over the part of the turbine housing I'm bolting it to (like the current setup)?
Make the triangle symmetrical like Tim's picture, or center it over the part of the turbine housing I'm bolting it to (like the current setup)?
Reply
0
0
Thread Starter
Joined: Oct 2005
Posts: 15,198
Total Cats: 1,398
From: Oregon City, OR
I'm making a Bbundy/FM DP brace, I've got the clamp, I'm thinking about widening it to fit a strip of metal so I don't bend my DP like Bbundy, and I'll either fab or buy FM's bracket. It's a complicated bend/shape in a shitty location, so it might be worth the $25.
Reply
0
0
no, *******.
you could do it symmetrical with a standoff at the turbo side to get the turnbuckle in the correct position. do you need a PS/MS Paint?
but the access to that middle stud is going to be rediculous with your manifold, where Lars's has easier access without the "collector" being in the way.
Reply
0
0
Joined: Jun 2006
Posts: 29,085
Total Cats: 375
From: Republic of Dallas
Reply
0
0
Thread Starter
Joined: Oct 2005
Posts: 15,198
Total Cats: 1,398
From: Oregon City, OR
Gotcha gotcha.
Here's your straight on shot, although it looks like you don't need it.
And round 2:
I may have done a few miscalculations and rushed the prototype into production. Sue me, I'm enthusiastic. ~JH
I'm not real happy with the welds or strength of this one, although the thin rod is more to my liking, along with the symmetry. This one was definitely quicker to make, but harder to get straight. You can see I couldn't get all the over lap I woulda liked on the rear post. And I am planning for a 3rd member, just hasn't been fab'd yet.
Here's your straight on shot, although it looks like you don't need it.
And round 2:
I may have done a few miscalculations and rushed the prototype into production. Sue me, I'm enthusiastic. ~JH
I'm not real happy with the welds or strength of this one, although the thin rod is more to my liking, along with the symmetry. This one was definitely quicker to make, but harder to get straight. You can see I couldn't get all the over lap I woulda liked on the rear post. And I am planning for a 3rd member, just hasn't been fab'd yet.
Reply
0
0
