99-00 Bee-R Revlimiter Wiring
#1
99-00 Bee-R Revlimiter Wiring
I got a Amazing deal on it so why not install it
Bee-r this is the wiring
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.
Red and Black- easy
Yellow- Will the CamShaft Position Sensor pick up an RPM Signal?
Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire?
Bee-r this is the wiring
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.
Red and Black- easy
Yellow- Will the CamShaft Position Sensor pick up an RPM Signal?
Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire?
#2
SADFab Destructive Testing Engineer
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
I got a Amazing deal on it so why not install it
Bee-r this is the wiring
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.
Red and Black- easy
Yellow- Will the CamShaft Position Sensor pick up an RPM Signal?
Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire?
Bee-r this is the wiring
Red wire: 12V+
Black wire: Earth
Yellow wire: RPM Signal
Green wire: Ignition signal.
Red and Black- easy
Yellow- Will the CamShaft Position Sensor pick up an RPM Signal?
Green- On the ecu pinouts im looking at the ignitor has 2 outputs 3g and 3h which fires cyl 1-4 and 2-3, Would i tap into both of these and then run it to the green wire?
And connecting both of the ignitors to the same wire would be really stupid, should be kind of obvious why. BTW CR.net has a lot of threads on this. They would probably be nicer than what you're about to get anyways.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM