Rewiring power windows to always work
#21
Another improvement would be to clean and regrease the window rails. This mod is cheap. Pull the windows out and the rails, clean the rails thoroughly and regrease with with an all purpose grease.
I did this to my red '96 over a year ago and it was a HUGE improvement. This was on manual windows, as well.
I can imagine how much better the power windows would roll up.
I did this to my red '96 over a year ago and it was a HUGE improvement. This was on manual windows, as well.
I can imagine how much better the power windows would roll up.
Last edited by johnwag; 01-12-2009 at 11:49 AM.
#22
Elite Member
Thread Starter
iTrader: (9)
Join Date: Jul 2007
Location: NYC
Posts: 5,710
Total Cats: 3
if it's anything like the NA, it's directly powered form the ignition switch.
[IMG]http://boostedmiata.com/technical/power_windows.JPG[/I]
page 22: http://www.madracki.com/miata/images/wiring/97sys.pdf
looks the same.
[IMG]http://boostedmiata.com/technical/power_windows.JPG[/I]
page 22: http://www.madracki.com/miata/images/wiring/97sys.pdf
looks the same.
#23
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,498
Total Cats: 4,080
who said you couldn't? sounds like the solution....especially since it seems nothing else is driven after the power window fuse, so only the switch will stay active, and nothing else will be affected.
#25
Elite Member
Thread Starter
iTrader: (9)
Join Date: Jul 2007
Location: NYC
Posts: 5,710
Total Cats: 3
Back to the drawing board.The ABS fuse is under the hood, the power window fuse is under the console in the cabin.
Ill have to source it somewhere under there.
What would you guys says is the min gauge wire I should safely run for this?
Ill have to source it somewhere under there.
What would you guys says is the min gauge wire I should safely run for this?
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM