My Grandmother called it a "Buffet". Evidently you can still buy them new.

http://www.crateandbarrel.com/organi...s-sideboards/1

 

It's a no-******* desk.

 

So I got a PM tonight after pissing off one of the gypsies on M.nets conversion section.

My return-

I know my spelling, grammar, and everything else SUCKS.

He refuses to post pictures of his build, yet brags about how good it is. Gay. I know my swap is a hack, but I'm willing to take pictures of anything on it to help someone else.

 

Im actualy proud you at least wrote " 'till" instead on"tell" like others I've seen.

 

Meh, whatever.

Needs more MCP.

 

Actually, did I mess that up also? Should it be 'til instead? I fail at this... haha

He didn't like it so much.

I was told he's going to put my "nuts in a vice".... Kinky

Finally found the ignore list. To think, it all started because I tried letting someone know how junk Optima batteries have become. Some folks just don't get it. If you are going to spend 200 on a battery, why not do it on one that weighs half of stock and puts out only what the starter needs.

 

I'm going to list it as a "Antique buffet sideboard server table w/ locking cabinets"

I'll be sure to add in the listing that its a "no blow job desk" so I can avoid any complaints afterwards. lol

Yeah not very exciting is it.

I have some cool stuff I'll be digging through soon. This thing is just to get the ball rolling. I want my foot in the door to get to the good stuff.

 

So I got the e8 error on my lc-1, and the xd-16 isn't allowing me to enter heater calibration, it just skips right to the free air calibration. I think the sensor is screwed.

 

So I found out that an EVO X with dp/exhaust will only get about 1 car length on me from a dig. Then he found out when the playing field is level (from a roll) that I was faster.

 

or you did something with the black wire. I wouldnt assume you could even go into free air with a e8 error.

 

I don't use the black wire becuse the gauge does the same thing. On a side note I'm going to look at a 95 Friday for a possible trade. Only issue It's sitting on ricelands.

 

they are comfortable.


So you didnt connnect the black wire to the LED/button circuit? you left it unconnected and taped away safely to never ever ever touch a ground?

 

It had never been striped for a connection so I left it alone. On a side note it will work for about 5min before I get the e8.

 

Here's that car i was referring to, I'm looking at it for 2 reasons. It doesn't have the rocker rust like most Ohio miatas, and it has a freshened up 1.8. The suspension can be fixed

 

where's the sensor located? did you try making an aluminum heatsink s shown in the manual?

 

About a foot from the turbo, no I didnt make the heat sink.

 

there's your problem, the errors are legimate.

 

So does that mean I fried the sensor, or just as the heat sink and it should be good.

 

I'd like to point out on page 7 of the LC-1 Manual:

and on page 8:

and again on page 8:

 

So I need to get a new sensor more than likely and add a heat sink like a smart person got it.