Every time I see your dash I do a little sex wee.

Love it.

How to control VICS, I see nothing in TunerStudio
 

I am looking for the place in TunerStudio to control VICS on my MS3-Basic (99-00 version), but do not see anything.

Any help on this?

How to set up Limp Mode(s) using TS?
 

How does one set up or test limp modes on MS3 using TunerStudio?

I see the CAN-bus/Testmodes, but don't see how to access most of the functions.

Note: I am OFFLINE. If I just need to be synced, then I'll figure this one out.

Serial number of ECU?

Test modes are not available offline or while the engine is running.

Thanks.

Any news on the MS3 enhanced?

Rev can you PM me w/ other contact info. Looking for a quote. (don't have enough posts here yet)
Thanks

I think you can PM vendors even with 0 posts. At least people in the past were able to.

Good to know. Excuse my ignorance

Hi Reverant,

In the SCCA Solo STS class we are allowed to adapt in a stand-alone controler but we are not able to add any sensors. We must use the AFM and throttle switch and can't add a MAP sensor.

Can your MS3 or some version of it work with this? Several others are working the same idea. There's a thread on the question here.

For me personally I need an STS compliant solution but would also like to some day put in an NB2 VVT engine or KLDE V6 (fully sequential). I'm wondering whether this can all be supported with a customized MS3 based solution.

Thanks.

Jay

PMed.

I am on the same boat on my MS3 basic, tuner studio has all the VVT setting options but nothing for VICS that I can find. Did you end up using one of the programable outputs and runing a wire from DB-37 to the oem harness?
Thanks

It's already controlled through InjH.

Great, now I know where to look.
Thanks!!!

Just tried to reference that awesome chart again. It seems like it's down? Can haz another link?

It should be working now once again.

Let me know if it doesn't.

Works for me.

Or he fixed it in 7 minutes.

More like 3 minutes.

It werks. Good jorb!