Faelflora breaks his promise, time to part out car. GIT THE SAWZALL!
#605
Elite Member
Thread Starter
iTrader: (2)
Join Date: Jan 2007
Location: Los Angeles, CA
Posts: 8,682
Total Cats: 130
I didn't use a kit. I made this **** myself out of pubic hairs and testosterone. I will test it's efficiacy on the dyno by disconnecting the **** on a back to back pull.
#607
??? What check valve of yours has gone bad? Are you running a slashcut system too? If so, please post in the crankcase thread.
I didn't use a kit. I made this **** myself out of pubic hairs and testosterone. I will test it's efficiacy on the dyno by disconnecting the **** on a back to back pull.
I didn't use a kit. I made this **** myself out of pubic hairs and testosterone. I will test it's efficiacy on the dyno by disconnecting the **** on a back to back pull.
#608
Elite Member
Thread Starter
iTrader: (2)
Join Date: Jan 2007
Location: Los Angeles, CA
Posts: 8,682
Total Cats: 130
OK NIGS
I'S BACK
Well not really. I am over in the gulf guiding our beloved contractor force on the global financial distraction named Gaddafi. All I have to say to our liberty loving brethren back in the states is "go long on the commods" and that is merely financial advice.
That said I have decided to run my GT30 to destruction. I will not send it back to garrett until the bastard turbine wheel shatters and explodes the turbine housing. I have vacillated between selling my hotside and going to a GT35 and I think I should just run my favorite little adrenaline providing boost **** until she breaks. I shall dub my turbo "Kaitlyn" after all the spawn producing 15 year old trailer trash I have encountered in my brief life. She screams when I boost her, and gets moderately moist and oily in the compressor but she boosts and boosts well. If she dies, $600 will resurrect her, and at that point I might say "**** it" and move to a better turbo....
I upped the boost to 20psi, peaking at 24psi, to try to keep up with leatherface (god among lesser beings) and resultantly, got unexpectedly and shockingly sideways at 80mph while attempting straight line acceleration on my POS RS2 tires. My girlfriend noticed, and calmly stated, "that doesn't seem like the best way to go forward quickly". I myself was rather shaken and decided that I should definetly set up traction control for third gear-- not just first and second.
I diagnosed my spark gap issue to my spark plug wires. To ameliorate my wire deficiency, I am ordering some 10mm wires from Magnecor. If anyone has better wires to recommend, please say so now or forever hold your peas. My "free" wires that I got with my coils were damaged because they were not the correct bootie type for the miata and I pulled them on and off a few times. Anyways, with good wires, I should be able to run .45 gap with no problem.
After the wires, that's it for the mods.
Dyno session is next week and goals are "ALL OF IT" at XXXpsi and 8500RPM, and my expectation is to only be limited by my fueling (stock '03 system with 255HP walboro pump and ID1000). I want to walk where eliminator has walked with a 50trim and hope to see over 500hp with 30+psi.
P.S. If I lay hands on one of Ghaddafi's mumu's I will trade it for a GTX3076...
I'S BACK
Well not really. I am over in the gulf guiding our beloved contractor force on the global financial distraction named Gaddafi. All I have to say to our liberty loving brethren back in the states is "go long on the commods" and that is merely financial advice.
That said I have decided to run my GT30 to destruction. I will not send it back to garrett until the bastard turbine wheel shatters and explodes the turbine housing. I have vacillated between selling my hotside and going to a GT35 and I think I should just run my favorite little adrenaline providing boost **** until she breaks. I shall dub my turbo "Kaitlyn" after all the spawn producing 15 year old trailer trash I have encountered in my brief life. She screams when I boost her, and gets moderately moist and oily in the compressor but she boosts and boosts well. If she dies, $600 will resurrect her, and at that point I might say "**** it" and move to a better turbo....
I upped the boost to 20psi, peaking at 24psi, to try to keep up with leatherface (god among lesser beings) and resultantly, got unexpectedly and shockingly sideways at 80mph while attempting straight line acceleration on my POS RS2 tires. My girlfriend noticed, and calmly stated, "that doesn't seem like the best way to go forward quickly". I myself was rather shaken and decided that I should definetly set up traction control for third gear-- not just first and second.
I diagnosed my spark gap issue to my spark plug wires. To ameliorate my wire deficiency, I am ordering some 10mm wires from Magnecor. If anyone has better wires to recommend, please say so now or forever hold your peas. My "free" wires that I got with my coils were damaged because they were not the correct bootie type for the miata and I pulled them on and off a few times. Anyways, with good wires, I should be able to run .45 gap with no problem.
After the wires, that's it for the mods.
Dyno session is next week and goals are "ALL OF IT" at XXXpsi and 8500RPM, and my expectation is to only be limited by my fueling (stock '03 system with 255HP walboro pump and ID1000). I want to walk where eliminator has walked with a 50trim and hope to see over 500hp with 30+psi.
P.S. If I lay hands on one of Ghaddafi's mumu's I will trade it for a GTX3076...
#609
Elite Member
Thread Starter
iTrader: (2)
Join Date: Jan 2007
Location: Los Angeles, CA
Posts: 8,682
Total Cats: 130
OK engine bay update game results!
Hmm. :| Already addressed. I do not use electrical tape. That is the tape of the plebes. Self fusing silicone tape for the ---- rampage.
What was your idea? Yes, that is a DEI volcanic wrap turbine blanket. There is also DEI volcanic wrap on the downpipe. The blanket can be had for cheap on... AMAZON. Not much more than the uh PTP or whatever everyone uses.
I also got rid of my ******* heat shield.
Yes I tried to find a teal sweat band and could not find one for under $12. **** that.
Yes I mounted the filter right on the turbo.
Yes I ripped off the ******* cold air box and my datalogs indicated NO AIT DIFFERENCE. SUCK A **** COLD AIR BOX. Note that my AIT delta vs true ambient is always like 20*. I am quite sure that my compressor and maybe hotside piping is heatsoaking like a mother. In heat.
Yes fitting is on the VC.
Random hoses and wires no. Damn it. Purposeful, yes.
Um I will look at my idle MAP when I am back from the promised land. Despite your lols Braineack, wouldn't more vac on the crankcase = more ring seal = more vac in the intake???? Yah I gotcha, I gotcha there don't I sweet ****? Doubt there would be more vac at idle though, there's just not enough exhaust velocity to make much of a difference :|
What was your idea? Yes, that is a DEI volcanic wrap turbine blanket. There is also DEI volcanic wrap on the downpipe. The blanket can be had for cheap on... AMAZON. Not much more than the uh PTP or whatever everyone uses.
I also got rid of my ******* heat shield.
Yes I mounted the filter right on the turbo.
Yes I ripped off the ******* cold air box and my datalogs indicated NO AIT DIFFERENCE. SUCK A **** COLD AIR BOX. Note that my AIT delta vs true ambient is always like 20*. I am quite sure that my compressor and maybe hotside piping is heatsoaking like a mother. In heat.
Yes fitting is on the VC.
Random hoses and wires no. Damn it. Purposeful, yes.
Um I will look at my idle MAP when I am back from the promised land. Despite your lols Braineack, wouldn't more vac on the crankcase = more ring seal = more vac in the intake???? Yah I gotcha, I gotcha there don't I sweet ****? Doubt there would be more vac at idle though, there's just not enough exhaust velocity to make much of a difference :|
#613
I have vacillated between selling my hotside and going to a GT35...
I upped the boost to 20psi, peaking at 24psi, to try to keep up with leatherface (god among lesser beings) and resultantly, got unexpectedly and shockingly sideways at 80mph while attempting straight line acceleration on my POS RS2 tires. My girlfriend noticed, and calmly stated, "that doesn't seem like the best way to go forward quickly". I myself was rather shaken and decided that I should definetly set up traction control for third gear-- not just first and second.
As for 3rd gear traction control, only a ***** runs boost control above 2nd gear.
#614
The delicious act of two men rubbing the heads of their dicks together, with one of the men's foreskin being stretched over the head of his partner's dick. Add a little leakage (precum) from one (or both of their dicks), mutual excitement, rubbing, grinding, heavy breathing and the result is a mind-blowing orgasm for both men.
"Alone in their personal sauna at home, Josh and Wayne glued their dicks together with a little skin and spooge and made love to each other's **** all night long...ahhh the joys of docking."
You need video of this 24psi shenanigans. I sense your ********* are finally dropping
"Alone in their personal sauna at home, Josh and Wayne glued their dicks together with a little skin and spooge and made love to each other's **** all night long...ahhh the joys of docking."
You need video of this 24psi shenanigans. I sense your ********* are finally dropping
#615
The delicious act of two men rubbing the heads of their dicks together, with one of the men's foreskin being stretched over the head of his partner's dick. Add a little leakage (precum) from one (or both of their dicks), mutual excitement, rubbing, grinding, heavy breathing and the result is a mind-blowing orgasm for both men.
"Alone in their personal sauna at home, Josh and Wayne glued their dicks together with a little skin and spooge and made love to each other's **** all night long...ahhh the joys of docking."
You need video of this 24psi shenanigans. I sense your ********* are finally dropping
"Alone in their personal sauna at home, Josh and Wayne glued their dicks together with a little skin and spooge and made love to each other's **** all night long...ahhh the joys of docking."
You need video of this 24psi shenanigans. I sense your ********* are finally dropping
#619
Elite Member
iTrader: (8)
Join Date: Dec 2008
Location: Kingston, Ontario
Posts: 2,910
Total Cats: 51
i say you get a custom borg turbo or something that will flow more with extended tips and **** so you can flow like a 35r with the same spool as what you have.
one of my buddies bought a turbo like this for his 1jz that fullrace modified. fullrace claims that their modded turbo will do this (i will keep you updated though)
one of my buddies bought a turbo like this for his 1jz that fullrace modified. fullrace claims that their modded turbo will do this (i will keep you updated though)