sorry to hear about the leaks.

I hate swivel fittings. My low pressure PS line leaks too...right at the swivel.

 

My bad, I had used Summit hose ends. Changed them to Earlīs non swivel today and there are no leaks now

Have the ps line made at a shop near by. Have not tried it out yet but I donīt think that line will be any problem.

 

i learned my lesson with summit fittings too...

all of them leak. spend the $3 more per fitting on real ones.

 

Who here likes

FRAGOLA FITTINGS

 

Using Fragola with the fuel rail and fuel pressure regulator. Donīt have any leaks there.

 

Just as long as its not summit.

i havent had good luck with swivel fittings in general.

 

The other guys in the garage uses a lot of swivels, but they are all Earlīs. No problems

 

This is starting to get somewhere. PAinted everything and it is all bolted on. Fixed the problems with thr relay to tha fans (had to change an output on the SM4) and the boost controller if fine. Just need to adjust the clutch pedal bolt the seat down and take the car out for a spin.

And now. A lot of picures







Yes there is a crack in the up right corner. But it is not visible so I didnīt bother to weld it together.

 

Looks great!

Very stealth!

 

love it! props.

 

Got to take the car out for a spinn yesterday Some auto tuning, but more is needed.

 

ive been out tuning inglars car now. everything is looking good, good response, smooth to drive, and it pulls, even if we have just tried it at 10psi.. the car is getting dynoed within a few days now

 

Really apresiate the help. Getting somewhere now Just hope the car survives the dyno on thursday.

 

Did it survive? Should have been some videos allready!

 

^ I'm with this guy. Updates pretty please! Love this build

 

Sorry guys, no dyno yet. Have a 270 degree error on the cam sensor in the engine management so the dyno was put on hold untill we get some answers from Australia. Not shure how this error will effect the VVT. So this year I will be a passenger to the Nürburgring.

But have at least done some auto tuning up to 0.8 bar boost with no problems. Starting to get fun now

 

Not mutch as been hapening here:( Went to Nürburgring as a passenger:( Got a map from Australia the week after and the VVT-controller works now. But have to do some redecorating so I donīt think I will have the monney for the dyno this year. There is a slight oil leak at the front of the crank shaft. This will be fixed during this years winter. Donīt have the energy to do it now.

The only thing I have done now is the front splitter.



[IMG]http://i348.photobucket.com/albums/q354/inglar/2001%20Sport/Bygging/bilde18.jpg
[/IMG]

 

What kind of wood is that and how thick is it?

 

More importantly (to me) what did you use as a connection point to the car?

 

I used 6mm plywood with two layers of fiberglass (mat) on each side. See the prosess half way down on page 11.