COP Thread
Thread Starter
Joined: May 2005
Posts: 80,552
Total Cats: 4,368
From: Chantilly, VA
i gotcha, i have 6 pms for pins in my inbox. will drop that **** in an envelope tonight. If you all pay of course.
some of it may take a week, since i only have enough for 9 extras currently, and you may have to wait for the rest to come in.
some of it may take a week, since i only have enough for 9 extras currently, and you may have to wait for the rest to come in.
With all the connector research everyone did, did anyone see a female connector like this? I don't have the option of just stripping the coil to make a PNP harness. I might have to get a weather pack connector to make my own instead. Thought you guys might know.
Hey, found the thread again. Thought it was deleted. Anyway, Brain, I need the paypal username to pay you for the male pins. I would also be interested in a response to the above post if such an item exists. Thanks.
-S
I got mine from Standard Kulak, and they came with connectors, although, one of them does not have a lot of wire.....
Had them in the trunk on sunday, didn't get a chance to chat about them though.....
So at this point, all I need is some wire.... and time. <G>
Dave,
Had them in the trunk on sunday, didn't get a chance to chat about them though.....
So at this point, all I need is some wire.... and time. <G>
Dave,
You are lucky Dave, You never mentioned that. Mine from plazek came with no connectors.
If that's the case, it is just finding the time, and the wire for the runs.... <G>
Dave,
You have bought the wrong ones for this type of application.
But all may not be lost. If they only have 2 pins, they may be the same as the 1.6 coils you have now.
Which means, you can have a try to see if those 2 pins are 12V and GND, and fire when GND goes low. Just like you 1.6 coils.
You would just wire the 1 & 4 and 2 & 3 coils in parallel to the samewires on your ignitor which IIRC are white (1 & 4) blue (2 & 3) and red GND.
Good luck.
Disclaimer: I take no responsibility if you blow your **** up as a result of this
But all may not be lost. If they only have 2 pins, they may be the same as the 1.6 coils you have now.
Which means, you can have a try to see if those 2 pins are 12V and GND, and fire when GND goes low. Just like you 1.6 coils.
You would just wire the 1 & 4 and 2 & 3 coils in parallel to the samewires on your ignitor which IIRC are white (1 & 4) blue (2 & 3) and red GND.
Good luck.

Disclaimer: I take no responsibility if you blow your **** up as a result of this
i think i blew up one of the coilpacks on my car, does any one know where else i could get these COPs? the yards around here are asking too much, theres not many newer cars in the pick in pulls around here, mainly older years.
ebay doesnt seem to have anything good right now either
ebay doesnt seem to have anything good right now either
he was getting them out of a junkyard in/around Cumming, GA I believe. Really not that far from me. I saw it on ebay at that time. 
www.car-part.com will show many, many junkyard/dismanteler sources to get them from as groups and individually.

www.car-part.com will show many, many junkyard/dismanteler sources to get them from as groups and individually.







