That looks a lot like the hose on a ford dpfe sensor to me.

 

You are 100% right. But where can I buy it in bulk?

 

Looks like the small hose is 3.5mm. Which is slightly smaller, but might still work.

 

oh. well I got some from Andrew when I needed some. Maby I shouldn't be saying this. Dunno.

 

Maybe check out a hydraulic supplier. It kind of matches the specs of some Parker tubing that is medium pressure series 156h, in a firesleeve. I could be way off but it may be helpful to look at Parker.

 

You've checked mcmaster? It looks very similar to the small coolant hose I used to buy there for the turbo before I went to hard lines. That was 3/8, but maybe they make it in a smaller ID as well.

--Ian

 

Both Parker and McMaster only go down to .25" from what I've seen.

 

It listed ID as 3.97mm and OD as 9.6mm ish. But I could have read it wrong.

 

Interesting. The 156h hose has a steel braid from what I can tell though. This is either fiberglass or fabric.

 

Alright. Another hive mind question.

This is the speedo cable hole, and I need a grommet for it. Anybody know where to get a square grommet?



Also got my final water line built/installed. All the wiring is done. I'll be pulling the spare motor out this week. Its now just a waiting game for the machine shop

 

Round it out and get a round grommet.

 

Pass. Thats a big hole.

 

3D print a plug. thats what i did for my antenna delete on my NA6.. worked great

 

Interesting. I might give that a shot. ABS should be able to take the heat.

 

the dealer doesnt have any?

 

Found something that will work. Square tube plugs.

 

That's what she said... damn it.

 

Why would the dealer have them? Was there ever an NA offered without a speedo cable?

 

ohhh your looking for a plug.

I am stupid. I am retard.