Aidan's loose oily bunghole actually runs a track lap
#6187
Elite Member
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
Oil/fuel pressure sender: Pressure Transducer or Sender 100PSI for Oil Fuel Diesel Gas Air Can'T for Water | eBay
I want to see all these things.
#6189
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
I have issues with grounding and 2 wires. Just annoying.
I'm not sure when they will go one. Projects have piled up, and ABS is more important than this stuff.
#6190
Elite Member
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
My MS3-B has inputs for oil temp and pressure, I just need to figure out what sensors I want to use, and how to physically hook them up. I was considering using the TinyIOx for this task, but I already have inputs.
Really? I'm actively looking for 2 wire sensors so I can control the ground path. I'm done ******* with 1 wire sensors.
Sweet! What value bias resistor are you guys using with these things?
#6192
Elite Member
iTrader: (37)
Join Date: Apr 2010
Location: Very NorCal
Posts: 10,441
Total Cats: 1,899
Yeah, I'm retarded. I realized my mistake but you responded before I got a chance to correct my post
I've been reading about sensors and inputs all morning, its starting to bleed together.
I'm guessing oil pressure, fuel pressure and ...?
I've been reading about sensors and inputs all morning, its starting to bleed together.
I'm guessing oil pressure, fuel pressure and ...?
#6195
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Ran out of other ideas. 1 for baro, one for map, the 2 for testing. Intercooler pressure drop, crank case pressure, etc. Exhaust back pressure.
General datalogging.
General datalogging.
#6196
I got the email, spanks! I'll take a look and see if I can funger this out.
My MS3-B has inputs for oil temp and pressure, I just need to figure out what sensors I want to use, and how to physically hook them up. I was considering using the TinyIOx for this task, but I already have inputs.
Really? I'm actively looking for 2 wire sensors so I can control the ground path. I'm done ******* with 1 wire sensors.
I feel this.
Sweet! What value bias resistor are you guys using with these things?
My MS3-B has inputs for oil temp and pressure, I just need to figure out what sensors I want to use, and how to physically hook them up. I was considering using the TinyIOx for this task, but I already have inputs.
Really? I'm actively looking for 2 wire sensors so I can control the ground path. I'm done ******* with 1 wire sensors.
I feel this.
Sweet! What value bias resistor are you guys using with these things?