allofit

now

 

I shall make you proud

 

 

Went to Miata Mikes/Miata Mecca today.





I haz tranny seals!!!!!!!!




Before

this doesnt really convey just how fuking filthy this trans was. PO must have had everything leaking ALLOFIT.





After




Arca_ex is going to help me stab it on sunday. I think ill drive it for a week to make sure everything is good to go, then go to the dyno.

 

I went to Mike's place yesterday too lol, you probably saw the burnt NB there.

That trans looks much better now.

 

Yea I saw that, looks like something in the trunk, or battery caught fire.

The turret was cruddy, I was trying to clean it from the outside and it wasn't working, so I pulled the cover, and hosed it out with brake clean. Once all the crud was gone, this was free to fall out.




It came from here.



I have dubbed this the "făggot spring". Because you need to pull the shift pins to replace it, which would necessitate milling off the peen marks here, and on the other side, and pressing them out.



The pins would have to be reinstalled to the correct depth and re-peened.


O-ring



You cant see it but the O-ring is in there now to take up the gap under the shifter bushing. *** you făggot spring





shifting from 1 through 6

Ready to go for tomorrow.

 

Did not hear the appropriate noises for shifting through a 6 speed.

 

ebay exhaust?

 

Eggxactly

 

Your 5 speed is ready Zach.



6 speed shifts great not sure what everyone complains about, maybe the shift quality goes to **** later in life, maybe its the syncromesh. I dunno. I did 1qt of valvoline syncromesh and 0.8 qts of amsoil 75w90


Im still on stock coils so i think im going to do cops asap just to avoid any issue on the dyno when im nearing 20 psi.

 

Any suggestion on COPs. Im looking for cheap and easiest install. D585s? toyota?

Vlad sell me something i can bolt on for like $18.50 shipped.

 

Toyota's aren't any stronger than OEM. Go with whatever @deezums runs. They are dirt cheap.

@ryansmoneypit might even have some sexy CAD files for brackets.

 

Deezums is the one that recommended the 585s. Awaiting bracket info.

 

Not $18 or PNP, but probably the hottest cheapest spark you can buy.

99 00 01 02 03 04 05 06 07 Tahoe Engine Igntion Coil Ignitor Pack 5 3L | eBay

Going to a pick and pull might be cheaper, maybe.

 

Now, how do I wire them to the 1.6 igniter?

 

I haz files. I have sinned, for I have Lagged bad on getting them up. I'll try to remember tomorrow.

 

You don't, the ls coils have ignitors built in. Basically just give them 12V and ground, tie the signal ground into ground, and bring as many megasquirt triggers directly to the coils as you can.

I made a PNP-esque harness by beating my ignitor with a hammer. I just jumped the triggers over inside the case, also think I spliced the ECU rpm trace to the diag/tach box in there too. The pins inside the case suck for soldering, if I did it again I'd just splice it all together. You can use the coil plugs on that strip of 4 as the end of the harness then.

 

Not sure if GM coils have a tach signal. If they don't you need a tach out circuit.

 

Transmission swap great success.

I want a turbo on the track car now. You ruined it for me.

 

Write TSE a big check and bolt an EFR on. Problem solved.