My awesome daily project 35mpg/150whp highway donut
#362
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
Is this something I can fix or am I screwed? This kind of sucks because my track car is kind of screwed-up right now and I can't really drive it.
#363
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
Graeme sent me this pic of the mod he had to do:
I'm watching google vids on soldering circuit boards, kind of a shitty way to start out learning how to mod this stuff.
I'm watching google vids on soldering circuit boards, kind of a shitty way to start out learning how to mod this stuff.
#366
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
Can someone please help me and and shoe me what a composite-logger sync 32 error looks like so I know when I have what I need to proceed? I made a few logs this morning and can't tell if it's happening or not.
Hold on, let me mouth some dudes first.
Hold on, let me mouth some dudes first.
#368
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
Here are a few logs that all have sync loss and I can't tell where which I found on the interweb from various cars:
Just about every one of those shows no break in the CKP/CMP patters. Damn, I'm dumb.
Just about every one of those shows no break in the CKP/CMP patters. Damn, I'm dumb.
Last edited by hustler; 10-12-2012 at 11:50 AM.
#379
Maybe. I just realized youre running a different trigger wheel than I, right?
I just looked back at my thread. I was getting error 32. My ckp gap was 1/4". Closed the gap to single credit card thickness (gap from tooth to sensor), and the error became less frequent. But what really fixed my problem was going from rising edge trigger to falling edge. Your input circuit setup is possibly very different from mine though. I'm running Frank's implementation of the NB input circuit.
I just looked back at my thread. I was getting error 32. My ckp gap was 1/4". Closed the gap to single credit card thickness (gap from tooth to sensor), and the error became less frequent. But what really fixed my problem was going from rising edge trigger to falling edge. Your input circuit setup is possibly very different from mine though. I'm running Frank's implementation of the NB input circuit.
#380
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
I tightened up the tolerance on the CKP sensor and I have about 45-minutes of logs with 1 sync loss event, #31. I am set-up on leading edge. Should I be concerned or switch to falling edge?