View Full Version : Prefabbed Turbo Kits
Pages :
1
2
3
4
5
[
6]
7
8
9
- The bypass valve and venting to atmosphere.
- BOOOST lessssss
- If i buy greddy???
- New wastegate actuator with great results
- Tony Or Begi?
- Where can I get a downpipe flange?
- head gasket
- what does the g stand for on td04h 15G
- Greddy Kit Turbo Replacement?
- cheap greddy kit
- begi afpr
- Would YOU put these injectors in your car?
- kinda scared
- High boost with stock downpipe, how retarded am i?
- Does anyone have the turbine outlet and wastegate outlet measurements?
- New manifold homebrew
- Flooding with Fuel!
- Exhaust system shopping
- opinion on the last few peices of my build..
- rx7 afm
- base greddy kit ?
- the ebay 16g turbo kit
- Idle Droop.........
- do i really need a intercooler
- ebay exhaust
- Turbo is on with Stripes IC setup. Some questions as I finalize install.
- Help: Installing now, airbox location question.
- turbo set up
- finally turbod
- Woohoo! New parts just arrived!
- Greddy 1.6l on a 1.8L?
- Anybody put together Stripes kit themselves?
- Preferred location for an inline fuel pump?
- One more oil drain line question...
- o2 sensor dead ? how to tell ?
- Shift points on stock GReddy kit?
- Bipes Settings
- It fits! 1.8 oil cooler/warmer on my 1.6
- Finally got my car tuned by accident.
- Limited access to turbo bolts!
- Spiking Causing Detonation?
- Is the greddy kit actually worth the effort?
- Finally...
- Rev Limit Crystals
- Question about the GReddy kit.
- Soap and Water
- more general noob questions
- Check valve on Bosch BOV?
- wastegate control
- Oil filter sandwich plate: what thread size?
- How high are you running with YOUR 1.8 Injectors?
- Strange Whistle/Rattle from turbo?
- Lean Tip in Killing Motors?
- Turbo noob
- injector clip question
- Colder plugs really make that big of a difference?
- Question About Foul Plugs.
- How high do you take your starion IC?
- used hks 1.8 1995 kit
- Third 323 Gtx Turbo Pvc valve broken, Whats up with that?
- Can I clean my own injectors?
- Reinstalling head - what head bolt torque for Greddy install?
- what is the ratio of the Vortech FMU?
- some minor changes to my kit, (diy fmic, reclockage, and rad photos inside) 56k -_-"
- cant find help on manifold relief cuts???
- begi and boost creep
- Hmm, overheating. How should I go about getting air through the radiator?
- Turbo's off and busy!
- Which way to face MBC?
- Finally boosted!
- total noob ?s about greddy before install
- New Intercooler, 56K Death
- Just the Greddy Turbo
- instructions
- Greddy Air Filter
- Reset Base Timing?
- Where to buy Greddy Kit
- Stainless Oil Return Line
- High RPM rattle--Help!
- I bought my first Miata + it's turboed!!!
- Oil Pressure
- Puffin Smoke
- Cometic HG or Felpro?
- Fuel Pump. Which size?
- Would this MSD work in a Miata
- GReddy T67 manifold Q
- New Used Engine on the way!
- Hand holding requested - oil feed and drain lines
- Fuel Pump buying question.
- SSautochrome turbo, direct bolt for greddy kit??
- oil return, teflon tape, teflon glue stuff, or rtv gasket maker ?
- Turbo Timer
- olderguy's o2 clamp help!!!
- HELP. Smokin turbo/BoV leak
- Anybody have a electric GReddy Boost Gauge?
- Coolant Leaking From Intake Manifold?
- front crank seal replacement q's
- Gauges?
- Greddy kit oil drain flange clarrification question.
- td04 downpipe flange?
- Jim B IC Pipes????
- Sputtering
- turbo vs summer
- Under/Over Torqued head.
- ?Lowered Boost pressure-Shitty MPG's-Decreased Vac?
- Miata turbo. Props to pro's
- Question About InterCooler.
- first things first after the install...
- A thank you to BEGI and this forum
- oil return help: fitting to go into oil pan, what material?
- Sac Town People.
- RM downpipe - what cat fits? Built on Pitlabs car incase you missed it 1000 times ago
- Intake Manifold
- When I let off the throttle in neutral, RPMs REALLY drop
- Intro and my Greddy install
- Fuel pump and injector help
- Question about Valves on head.
- More HP to my Greddy kit
- Will this Ebay Downpipe work on the greddy kit?
- Boost Controller...Have you heard of this one?
- OH NO! Whats wrong with this Dam Motor D:
- Takin Head off!
- Jackson Racing AFPR
- Spike With EBC?
- Questions about mildly building an engine.
- injectors
- Tdr Fmic
- Speaking of Greddy Chat....
- Garrett .42 a/r T3 better than the 15g?
- Turbo Upgrades
- Is this the definition of hesitation?
- Compression Test.
- boost question
- Yellow Top Injectors...
- greddy upgrade mani and dp?????
- Cleaning Turbo's.
- TRACTION! How do you guys do it.....
- How high with a Greddy?
- oil restrictor???
- So what else b4 I finally go turbo?
- oil feed line? where to get them
- Catalytic Converter has gone bad
- Just got off the phone with greddy.....
- bov question
- Dicking around with o2 clamp, what's it supposed to feel like?
- new manifold?
- need oil feed help: thread, tubing, etc.
- Greddy TD04+TEC2?
- Installing an extra water temp and oil pressure gauge
- Wiseco pistons @ stock bore?
- Shaved Heads for Higher Compression.
- Zeitronix map sensor VS GM 2bar
- Fuel Pump Application.
- greddy kit install ><
- Injectors too big?
- A little help with IC routing..!
- Moving to San Diego from Canada
- Guess what, I bought a stupid MSD box!
- Has anyone actually gotten decent results out of the BEGi downpipe?
- Boost Drop With Stripes Kit
- question on crankcase breathing
- Greddy Type S BOV Problems
- which way to go now????
- Can Anyone ID these injectors?
- Question about plug for oil return line by oil filter.
- GReddy needs a turbo miata for testing!~
- intercooler placement with half size radiator
- Glowing turbo and 3psi?
- Wiseco pistons $439
- Bipes Installation Question.
- HOW not to blow up your Engine Guide
- Question about MBC's.
- Sudden lost of power!!!
- anybody get extra greddy carb stickers
- Bolt size at turbo
- Biggest ebay FMIC that can fit?
- Stock Intake Hose + Greddy
- boost drop off????
- Anyone hear of this turbo kit?
- Idle issues
- Flyin Miata greddy heat shield fitment question.
- Poll: Greddy oil drain.
- Installed Greddy Turbo Kit and....
- Need some help, vacuum leak somewhere.
- well my car is fucked...?
- manual boost controller question????
- Turbo rebuilt, and now another problem...
- uping boost, timing question?
- How many psi can I run with this setup?
- I know Jim B is taboo,but....
- Turned up the wick!
- Newby? HOW DO I INCREASE MY BOOST???
- About to install greddy...
- Difference between US an JAP kit..
- gasket help
- Mixing clutch parts: OEM disc, ACT pressure plate
- Different turbos for GReddy Kit? BEGi DP fitment issues
- .....wow.....
- Smog! Dam!
- BEGI Downpipe, am i ordering wrong?
- newly rebuilt turbo question...
- Will Tony's DP bolt up to stock exhaust?
- How much timing at 14 psi
- Greddy on Automatic 1.6 Miata
- Just got my kit, have some questions.
- Scary/Smokie oil leak at Boost!
- Found something inside my TD04
- afpr install? which hose goes where?
- FMIC Installed
- What IC do you recommend?
- just back from a 'real' track event, story inside = )
- bosch bov orientation?
- second problem with etd manifold
- JUST PURCHASED A BUILT TURBO CAR, request your wisdom
- About to pull the trigger on this clutch...
- Manual Boost controller
- Added adjustment to the Vortech...
- Halfshafts
- Intake location and its affect on AIT
- Anyone know the size of the intake on the throttle body on a 1.6L?
- help find fitting
- Lost My Boost
- fuel pump Q?
- ordering replacement greddy oil lines - criticize my work!
- New pump and injectors and more problems...
- Clarifications on an AEM Wideband...
- 163rwhp... But kinda bummed... Huge lean spike!!!
- new to miatas and looking for advice
- Greddy Boost Increasing Parts
- overheating, water temps high while high speed crusing, blah blah. suggestions?
- Slippin clutch & High idle
- Newbie asks ... what's a good (budget) EBC?
- New guy checking in
- First post! YAY, Newbie question about potential of greddy kit
- who else is running an NPR IC
- greedy emanage ?
- another noob question...
- really stupid ?
- Replace standard bolt with studs or bolts?
- Bocsh BOV fart sound?
- Greddy I/C piping pics?
- silicone couplers for greddy with jim's stuff
- Reloacated AFM - pics
- Survey: Ford Vs Chevy?
- Help!! Which Is The Right One!!
- 4-wire O2 ground location
- Vortech with Greddy Kit
- hose shielding
- anyone running greddy w/ link
- Greddy mani stud size?