- Please help settle a brake bleeding argument.
- Ebay RX7 shifter onto 6 speedbox. DIWhy?
- Driveshaft question
- DIY alignment equipment
- Brake duct inlets for NB's
- Na tophats with megan coilovers?
- I LIKE the STOCK MIATA SUSPENSION BETTER THAN ANYTHING ELSE!! But I have a question.
- Auto NA 1.6 trans prep for Supercharger
- Coilover choices?
- MFactory upgraded gearsets
- Anybody quiet down a noisy Findanza FW ?
- Rear Squeak/Creak when taking off
- Need help buy bigger calipers for my 90 miata
- Koni Yellows, adjustment knob doesn't turn...
- Poly urethane spring isolator for NB
- Differential whine
- How Hard is launch Control on the Drivetrain?
- terrible rattle from clutch?
- Suspension Considerations 245 Maxxis
- Brake Duct Hose Material
- Torsen rebuild questions?
- Shock tower dimensions
- Loud clicking from 5 speed.
- RX8 ring and pinion in NA/NB
- Fab9 Brake Booster Delete/Manual Brakes
- Do all Sport cars come with bilsteins?
- ELBJ Alignment on Stock Suspension [NB]
- Need Comp engine mounts, in FL
- What about a 500tq transmission?
- Does NB ABS generate reverse pressure?
- Brake fluid moisture tester
- Help me pick a clutch?
- What the hell is in my car...? (First post.)
- Ring and pinion swap with solid spacer
- 1.8 torsen diff
- Which shocks for better bilsteins?
- The budget baller shock dyno thread
- 949 twin replacement discs for older clutches
- Extended Ball Joint issue
- Speedo Sensor: '90 4.3 VLSD to '02 3.9 LSD
- Need expert eyes to ID this diff.
- Front suspension knock on load
- Hypothetical Transmission
- FYI Alignment in Memphis
- V8R engine mounts?
- Air Bags
- Can anyone tell me the thickness of the tranny switches spacer???
- Raceland coilovers:good, bad, or ugly?
- Time to play "Name that noise"!Time to play "Name that noise"!(Clutch/Trans related)
- Is my front Wheel Bearing on its way out?
- ELBJ ; Extended Lower Ball Joints
- FYI -- AST 4100 shocks for $1000
- Steering wheel
- Super loud diff
- FM Springs / Tokico Illumina assembly trouble
- Alignment feedback for my numbers
- Control arm bottoming out on body
- Mazdaspeed Front Sway Bar Collar Issue
- DIY alignment observation
- Moving rear subframe back one inch
- Replace just the diff part in '03 Tochigi-Fuji rear?
- Carbotech clicking. Sounds scary
- What to clutch it ?
- AP Racing 11.75" Rotors for your BBK
- Why does my $5K diff/rear end setup not lock when lifting a tire?
- TEIN coilover help
- ITT: We discuss T5 swaps and other information.
- Lightweight Front Hubs
- Fully Adjustable A-Arms
- Slipping clutch on the dyno only (?)
- Quaife Sequential for the ND
- Brake pads, beating a dead horse.
- Stage 2 Clutch
- Strange Squeaky Sound
- Did I finally break my 1.6 trans?
- How Much Braking Power Do I Really Need?
- Carbotech pad thickness
- Sanity/ Logic check before $$Baller Brakes$$.
- Lets talk wheel speed sensors
- Is the space on this dog bone bolt okay?
- Trackday Brake pads
- ABS Test Diagnostic Port pin bridge
- Rear dif bushing explosion?
- Big Brake fun
- 5 Speed Tranny - How it works (primer)
- Cheap rear sport pads that don't bite too hard
- Rear Metal on Metal Noise
- Wilwood NPT-AN adapter torque spec
- Six Speed reverse gate detente
- So I got a junkyard Miata for $700 and it had a happy meal (no for real)
- MSM Springs on Hards S Bilsteins or NB OEM Showas - Ride Height?
- assuming so, but 6 spd ok with 1.6 clutch?
- Driveshaft STUCK to differential
- Help me drive to the alignment shop
- Glass / metallic brake pad options
- Weird Suspension Noise
- Bilstein PSS9 Question
- depowering na8 steering rack? what am I missing??!!!!
- Tochigi Fuji Diff - Worth $200?
- Daily driver suspension suggestions for NB1
- Looking for feedback on Xida spring rates
- Best way to pimp my yellows?
- Supermiata Sport Clutch
- prop valve and trailbraking
- Wilwood 11.75 Rotor Defect
- 6 speed swap turret fitment
- Help me improve my dual duty NB 1.8 Turbo
- Streetable aero possible?
- Ring and Pinon Swap - Help Setting Pinion Depth
- How did I screw up my NB charging system??
- MSM differential issue in 1990 miata
- Ohlins Longevity?
- JIC Coilovers
- Is this any good?
- Can anyone recommend good shocks/springs for my bumper?
- Brand new miata drive shaft u joint ?? Kitten inside...
- Rear subframe brace installation trick?
- rear lower control arm shock mount captive nut striped!
- Mazdaspeed inner CV on regular outer axle
- How to choose transmission ratios?
- KONI RACE SHOCKS
- Oh no not another diff question.
- Outer front pads getting much hotter than the inner
- Differential selection question
- Help me ID this alu flywheel
- Car wont go in gear when hot
- Diagnosing an issue near rear passenger wheel
- Auto boxes
- Dynapros Bridge Bolt
- xida install question (stacking bushings)
- Xida service & installation videos
- ND transmission failure.
- Getting ride quality back. Going the opposite direction of most of you.
- What's wrong with my 5 speed?
- Another brake pad thread.. daily vs track
- Rusty Shell Swap
- 99-05 6 speed tranny output shaft splines count
- SM hybrid mount material?
- Bad Pedal Feel, possibly parking brake related?
- fab9 act xtss vs FM level 2
- AST 5100 or Xida Gen 2
- Exedy Flywheel Fitment issues
- rx-7 in miata driveline swap
- Push fit wheel bearing to knuckle fitment?
- Misc. Rubber on Damper Assm.
- Six speed shopping list
- 7.6 section width tire, would 7.5" or 8" provide more linear breakaway?
- Need suspension help, feel free to rip me a new one.
- Cut the bump stop or not
- Pre bedded brakes
- Did I ruin my caliper?
- OS Giken Questions
- Half-Car suspension simulation
- Eccentric locks
- Issues with MiataRoadster Shifter... so much play
- 6 speed transmission bolts...
- Help with clutch kit * international version*
- Review: SADFab Delrin Bushing Kit
- Tranny fluid reservoir?
- Bilstein B8's for coilover's???
- MCS shock review
- Rebuilding/adjusting preload on OEM front hub?
- My car sounds like a metronome
- Mazdaspeed Differential axle seal?
- Searched a million times over.... Lower control arm bushings
- stuck in 5th gear, not in reverse
- ABS Swap Wiring Questions
- 6 speed lost 4th
- extended rear tophat with mcs?
- FM stage 2 or act clutch?
- Adjustable Upper Control Arm
- Just noticed broken passenger side coils. Ugh.
- Keisler Automation Drop Spindle kit, worth it?
- Anybody Interested in adjustable aluminum tophats?
- Black Diamond brake set?
- The Miata Bushing MEGAthread: Heirarchy, DIY delrin dimensions, info and discussion
- Koyo radiator and racing beat hollow sway bar fitment
- Open diff '96 to '99 Torsen swap question
- 5 lug conversion.. miata spindles on a triumph
- Will the 6 Speed hold up to....considered discussion
- Has anyone else's torsen taken a shit?
- JO Motorsports- anyone have experience with them?
- Steering Parts Questions
- Stupid big brakes. Wilwood Superlite option for Trackspeed 11.75" kit
- Help with my noise rear
- Blueprinted hubs - Mazda Comp vs. TCM/ART/5XR
- What's the difference between these two Torsens?
- MAKERS: Solid steering rack mounts
- Free Rev Comparison
- EBC Green stuff fade very quickly
- Identifying NB Sport Non-ABS booster
- Delrin Control arm bushings... yay or nay?
- When to revalve Shocks
- XIDA Gen2 700/400 Coilover Review
- 6 speed - cracking in tailshaft housing?
- Bilstein vs. Ohlins for DIY coilover?
- Spec Miata Suspension kit for $600 - Should I buy it?
- Anyone had issues with Garage Star diff bushing fitment?
- Weird noise is pissing me off
- Determining Braking Compound
- HELP...Wilwood Brake proportioning valve install...
- Billet coaxial shock mounts
- Is this possible? Mercedes calipers
- offset bushings vs. extended lower ball joint
- Brake Booster Delete
- Stability in braking at high speeds
- Depowered steering rack
- Caster issue - only 3.5 on left, but 5 on right: what is problem
- mix and match clutch parts?
- Polyurethane motor mounts
- Yonaka NB coilovers in NA car
- Ford transmission fluid in Canada
- 6 Speed automated shifting system idea
- push clutch in engine doesn't like to stay running.
- Clunking low speed braking
- Boosted folks with taller final drives... happy?
- My Flyin' Miata v-maxx review from track records to cruising with my gal
- Bleeding brakes - Pedal bottoming out
- Front UCA Bushing Question
- Clutch Upgrade from ACT Xtreme?
- Street Car with 3071R : 5 speed with 3.9 OK?
- Alignment Issues, Inner tire destruction
- A tranny option
- Yellow-speed vs V-maxx coilovers
- Clutch/Flywheel for Double Duty Car
- Top Hat Height - Bump/Droop Ratio
- Open diff blown out, can he weld it?
- Steering rack position, bump steer, etc
- Diff Companion Flange / Pinion Damper Knocking
- Front Brakes Dragging When Hot
- Strange Brake Troubleshooting
- OTS Bilstein to motorsports ASN conversion
- Leaky Wilwoods
- Odd Steering issue
- Koni 1150 Coilover Kit
- Replacement clutch disc for FM1, or something else altogether?
- Rear Sport brake wheel sizing.
- Wilwood Dynapro/dynalite maintenance
- What happened to my Dynalite?
- Upgrade my MSM coilovers springs or KW ?
- 1.6 clutch/flywheel on 1.8/6spd
- Stripped clutch slave bell housing threads.
- Flywheel with a lower MoI than the Fidanza 1.6?
- Re-Spring Tein FLEX or replace?
- Wilwood Corrado bracket measurements
- Removing speedo sensor from gearbox
- Can't Wait for 949 Clutch Anymore
- 10 inch rear brake upgrade?
- Vibration at 70mph after torsen install
- Clicking from wheel under cornering load and clunk from braking