View Full Version : DIY Turbo Discussion
- sweet deal on a begi t3 mani
- Request: air intake temp AIT data
- Intercooler question and piping
- SRT-4 stage one injector compatibility?
- how the heck do you get the nut that holds the compressor wheel on, off?
- I need advice on a good cheap mani for my t3, and a way to mock up a downpipe
- afpr question
- Neo's spend a lot of money to build your miata thread!!!!FUN
- Here's What I've Been Up To
- Quick turbo opinions please - GT28 or T3?
- Finally FMIC but overheating now..
- What pieces needed for turbo back exhaust?
- 1.6L HKS Manifold Question
- Bout to junk the Link and go elsewhere... Where to buy from?
- quick question on plumbing a fuel pressure riser..
- Turbo Caravan injectors
- FM Link and Innovate DB Wide Band O2 (Lc-1)
- Link ECU and Injectors
- How much boost on 320cc injectors
- clutches
- how to help oil lines not leak
- Rx7 injectors identification
- Intercooler pipe routing
- How to control Radiator Fan via Link
- SAFC 1 on a miata 1.6 nb?
- NA Lower Intake Air Temp
- What would you do? Compressor related.
- Where to find 1/8 bsp tee?
- Need help with DIY turbo parts
- Flanges!
- Connector for original fans
- BOV flutter or surge?
- Need a downpipe fabricator
- Yet another honda question...
- 1.6 t3 turbo manifold advice?
- Which WBO2
- looking for a turbo for my megan manifold
- 16g Turbo kit.
- will somebody explain to huslter how the PCV system works w/ a turbo
- link ecu with 550cc injectors
- Link ECU install - Should I? Or not?
- bolts or studs
- whats the best wat to drill/tap the oil pan?
- Need AFR help with LC-1 and BEGI FMU
- Ebay turbo ??
- nitrous ?
- Question about pipeing size for a t25
- what ratio on a FMU for 5psi with a t25 turbo?
- I'm not sure what this is, I found it under my seat.
- Oil and water lines
- T25 Oil Restrictor (Need Opinions)
- T25 too small?
- colder plug part #
- Junkyard hunting
- Current best place to get injectors cleaned, patterned. flowed and balanced?
- Airesearch m11 turbo
- Tight Radius DP
- Intank Vs Inline Pump
- intake bypass size
- OC'd ECU question
- Question about how eaisly a turbo should spin
- My "Little Project"
- airflow in the NB
- garret turbo question
- Choosing an air filter for a tight spot
- nissan 300zx and SR20DET
- Old Begi IC and piping confusion HELP!?!?!?!?
- 24psi=225hp@5500rpms?????
- aftermarket fan question.
- BOV flow direction...
- tony's email
- thinking about selling my car...
- SR20 T25 Wastegate options
- Connect Turbo inlet to AFM
- What do you think?
- Went to the track today
- Math Check
- cheap bosch bov replacement
- WRX TD04H turbo on a 99 miata
- fuel injectors
- AFM- major restriction?
- Wondering what cars I can beat at 8psi
- Seem pretty nice, decent price, worth it?
- Saw Turbo Specialtiess Kit: LONG POST
- running lean again
- 99 just went turbo and having ridiculous problems
- Turbo manifold fit ?
- Help me identify this setup.
- Drilling and Tapping oil pan?
- How much oil drain hose do I need?
- Witchhunter.com cheap insurance!
- DIY low profile headlights?
- Injectors
- diy dual feed fuel rail confusion
- I am one lucky SOB! You're not gonna believe this!
- Internal wastegate actuator...
- saw this in m.net classifieds noob q's
- probably been answered before.
- Ah SHIT! Too good to last.
- knock sensor on 99
- cold burning spark plugs and wires
- HKS manifolds and DP
- My balls have finally dropped (Philip didnt do this one)
- Old Spark plugs
- Stupid Newbie Question
- now here's why I think fuel is important too
- Hope this works this time!
- NOVA pre-Summer Tuning Day
- 22psi
- Tell me about this turbo please
- turbo advice
- wanna see why timing is important?
- Newbie needs help on a Turbo kit
- I am so close to getting banned again.
- which of these turbo rebuild kits is best - differing # of parts included
- Old Begi Areodyne manifold to T3 adapter plate
- Airfilters
- kits in california?
- MBC's..Should I buy one? I have tons of money. Maybe an EBC.......Help!!!!
- Question about detonation?
- Datalogging Bandwagon
- Flyin Powerlink
- Seeking datalog comments
- NB (M2) 1.6 fuel rail = NA (M1) fuel rail?
- heating problems
- fuel pressure gauge location?
- what makes your air temps hit 60C on a 20C day.
- Ghetto Heatshield #2
- Time for my very own build thread! (oh god please help me)
- Running the car w/o intercooler pipes
- Turbo Upgrade Help Pls
- Synchronic Blow Off Valve
- TWO wierd sounds from turbo....
- infon about my 14b miata
- What can I install and still keep the car on the road?
- So sick of stuff not fitting
- I can see my FUEL PRESSURE!!!
- Should I be able to turn up the boost more?
- is 18 or 20psi safe??
- i jock y8s style.
- 616 rwhp miata
- my completed turbo pictures. version, uh, 2. 56k death.
- Intercooler End Tanks?
- what size catch can?
- Double Catch-can setup?
- Tuning by EGT
- T2/T3 hybrid?
- Tech help - 4000rpm stumble on accel
- Anybody running a MSP GT25?
- Can I put a SR20 exhaust housing on a DSM t25 turbo?
- Looks like I have some build issues
- y8s diy turbo sample dyno run!
- Running a 4 wire O2 sensor with 1 wire?
- turbo question
- T3 50 Turbine Map?
- Quick drive w/305's, think I'm rich?
- Need 1" to 1.25" short adapter hose
- Heat shield project started tonight
- Cannot make boost with a MBC
- are the flywheels of a miata and a 323/protege the same??
- Well, I HAD wastegate creep...
- 14 b wategate question
- bov question
- turbo compatibility
- wide band sensor
- intermittent stalling problem
- Haste radiators?
- what heat range plug
- XTD Clutch
- Going Disco Potato
- LC1 woes
- Confused on how to install Vortech FMU
- different price....
- JR timing control?
- 5th injector
- rattle can aluminum charge pipes?
- Damm Kinda Slow in Here today!
- so I got this fuel pump
- hissing sound from back of intake manifold
- Post your exhaust sound and setup
- Greddy kit at 250whp 94-95'...
- Pleaz help with S-afc
- oil filter adapters
- dual feed fuel rails
- Help with friends DIY turbo civic.
- help with bov
- S-AFC in "MAP mode"
- How am I doing so far. Suggestions to complete?
- a new style intercooler?
- Boosted At Last
- what exactely do i need?
- apexi avc-r boost controller question.... in an installing mood
- about turbos
- Final details help with oil and water lines and DP
- Do I have to clock this turbo????
- video: 2nd-3rd acceleration
- Need opinions about injectors
- DE-turbo question
- Weld turbo to manifold - bad idea?
- does your FM bov sound like a turkey
- IHI RHB-6 rating
- T-ing off the oil sender HELP
- By jumpering you mean....
- Flexible intercooler piping?
- MBC - how do i plumb it ?
- Silly question about the MAF
- I need Help! My car will start, then shut off
- Ok masterminds check me out
- Calling all people with a T25
- tapping the sump - HELP!
- Hks Bov
- DIY turbo on a 1999 Miata?
- 1.8 DIY Build
- GT28R oil/water feed fittings
- Connecting TDR i/c to BEGI setup
- ETD Manifold-turbo match
- Mix n match BEGI, FM, TDR
- need a cheap clutch
- is this exhaust good or crap
- Let the weekend begin (Semi-Build Thread With Pics)
- chewed up crank and thrust bearings????
- Let's talk cranks, trannies (the metal kind), and diffs
- Ahhhhhhhhhhhhhhh!!!!!!!!!!!!!!!!!!!!!!!!!!!!
- Possible mx6/626/probe injector discrepancy?
- Vacuum/boost sources for everything
- Turbo exhaust question
- FPR Install question
- throttle body
- Overboost event - how to know if something has gone wrong?
- Aurora Motorsports is on hold for a few weeks
- Grassroots Motorsports challenge car
- mazda 323 gtx piston measurements
- Only getting 4PSI - (also posted in EManaged Section for wider potential advice)
- automatic tranny?
- Pierburg Fuel Pump
- Mixed News
- turbo question
- Clocking a 16g Turbo
- A couple DIY questions
- Heat vent in Firewall?
- mazda-323-gtx-miata-turbo-pistons-1-6-liter
- DIY fuel return restrictor/pressure increase?
- What DO you need to weld aluminum?
- 1.8 injector specs - discrepancy in the FAQ?
- Another silly question - MSD timng unit
- stroker crank?
- Michael (TheBandit)
- Injector question?
- car stalling while downshifting
- T25 help!?