View Full Version : MEGAsquirt
- Wideband CAN module settings
- MS3 Fan Strategy?
- Rich on start up
- MS3X no mainboard trigger signal
- MS3 PNP-Pro Idle
- Voltage climb
- DIYPNP Bad MAP Signal
- IAT sensor location for NA motor
- MSPNP2 firmware upgrade 3.3.0 to 3.4.2...TERRIFIED!
- EFR 6758: pls sanity-check my tune
- VVT Issue
- Look at my tune?
- Menu change confusion in latest tunerstudio
- large pulse width but lean afr
- MSpnp pro 91 vvt swap not starting, again
- DIY PNP no spark, no fuel, no rpm, CAS?
- GM IAT and rad fan issue.. please help!
- Odd VEAL behavior, consistently wants to go rich at low load.
- Input Conflict - VSS & Flex
- Lurker is still dumb, needs help with tune/reading plugs
- Reverent- Can I send you my MS2E?
- Awful popping. Can't tune it out.
- Megasquirt3x question
- Closed loop idle target RPM reading 0
- Crank no start after turbo install megasquirt.
- Car running on 3 cylinders after rev limiter
- Need some help with AFRs
- Trouble with Triggers
- Tunerstudio Composite Logger- Red Trace
- 1990 DIYPNP Not Starting
- Pls Help ASAP!
- Confirm i toasted my board?
- Ms3x Connection issues
- SD datalog problem
- MS3x - Cranks but No start (Settings issue) 01 VVT Turbo Build
- MS3X injector circuits
- ms3x na 1.6 wont start
- Spoon feed me Tuner studio basics
- MSpnp pro for 90-93 for vvt swap issues
- MS3x A/C idle up turns on around 4000 rpm
- MSPNP2 Not reading MTX-L Wideband and TPS
- VTPS values don't change in calibration
- Car feels like running on 3 cylinders
- gauges are dead and running rough
- Need Help With Idle
- MS1 After Start Enrichment
- MS3x Issues
- Help with ms3x on 1990 with 1.8 swap
- Please critique my tune
- MS LABS MS2 Extra CAN Bus AIM SOLO DL
- no spark after intake manifold r/r.
- BMW VTPS fluctuating readings
- BMW VTPS fluctuating readings
- DIYPNP VSS NB1
- Bluetooth module cable sync issue.
- EGO Correction PID
- MS3x died, not getting power.
- Changed from MAF to IAT on MS1
- Megasquirt/TunerStudio "Tips and Tricks"
- 00 DIYPNP crank but no start help!
- Another TPS/ground issue
- Weird vTPS problem & running rich randomly
- MS3X Grounding Issue?
- DIYPNP Closed-loop Idle AC trouble
- The Actual Process of Switching to E85 (Questions)
- Battery Voltage Increases with RPM even after changing Alternator
- Cycling Idle, bucking cruise.. car is now a rodeo
- DIYAutotune EBC on MSM stock wiring?
- New Build...Won't 'Start'
- poormxdad's (as directed) new noob questions thread
- DIYPNP Startup Issue
- RPM drop when A/C cycles OFF?
- 96 N/a 1.8 TPS weirdness with a MS3X
- MX5 VVT swap troubles
- launch control setup
- Vacuum Lines
- MS3x with Knock module Brain built
- Megasquirt 3 wiring into 1990
- Pulling mspnp2 file from car
- Voltage calibration accuracy?
- Cooling fan issue
- Mustang Injectors, misfire, car feels slow
- Brain DIYPNP map on MSPNP2
- Paramedic conniptoin? What does this effect? Only fueling? Or fuel and ignition?
- Could someone help me with my startup?
- What the f*** is happening with tunerstudio?!?
- Mustang EV14s No Start
- Flex sensor, ms3x not reading anything?
- N/A to Boost
- MS2 USERS OF 09 PLS HELP ME
- WTF is going on?
- need help asap burned coil
- VE Table Switching
- MS2E erratic MAP sensor adventure
- Setting up Launch Control
- MsLabs Ms2e ini file
- MSPNP2-9093 in '96?
- Idle valve while cranking
- Has your tune ever gone wacky when you don't burn any new tunes in???
- PWM crank duty or cranking PW%?
- WTF? A truly great idle mystery?!?
- Nooby Over-run Fuel Cut question
- Acceleration Enrichment
- Glowshift wideband install help
- Reverant Ms2 Enhanced
- Hesitation when giving it the beans
- Megasquirt R33 Burning up
- Mk2 1.8 Ms2 into Mk1 1.8
- MegasquirtPNP Gen2 and MS Labs CAN Wideband Module
- CLI, is it necessary?
- Can I tune these problems out of my 1.8 swap?
- Explain ASE Taper to me
- DIYPNP Scripting
- 02 Sensor Issue?
- Remote tuning
- Gm iat static 70 degrees
- What are normal TPS readings after calibration?
- Idle, dashpoter adder parameter...?
- 94 N/A running rich with all maps
- DIY - Raspberry Pi Racedash
- Innovate LC-1 --> AEM wideband, change any settings?
- MSPNP - RPM not dropping when shifting
- What percentage correction is 1 AFR Unit on the VE Table?
- MS3X Hot Starts Idle like poo poo?
- Downloading Shadow Dash on Android Phone
- another ms1 to ms3x writeup
- rev MS2 - A/C not working & not in programmable outputs
- DIYPNP NA Idle setup
- Ms2 noob for nb1
- Ran VEAL and it made things much worse???
- Reverant ms3
- Brain MS3X Idle 'Issues' (Idles at 3k)
- Car backfilres/dies when driving
- Megasquirt Fuel & Injector Managment
- Confirmation on cam vs crank sensor inputs
- All of the sudden, failed start
- DIYPNP losing sync entering idle
- ID1300 Deadtime Voltage Curve and Non-Linear Small Pulsewidths
- Won't make more than 4lbs
- Bought used ms1 for 1.6l should i use or sell
- Idle Issues/No AFR Reading
- MS v2.2 to a DIYBOB wiring
- Quick question about idle tuning
- DIYPNP(MS2/Extra 3.3.3) 1995 miata No Spark
- Looking to do a DIY MS3
- Knock Sensor Filtering
- Ms3 basic 2000 Miata ac Programmable outputs
- Has anyone successfully tuned DW1000's?
- Help me scale my tables
- Rev MS3 in MSM bogging under boost
- DIYPNP 99 Help Needed Misfire/No Idle
- Brain built MS3X EBC
- NB1 Idle hunt and stalls after voltage fix
- Crankcrankcrankcrank... '99 n/a MS3 - No Start
- DIYPNP Boost Solenoid mess with CAS signal
- Motor Swap / Megasquirt - No Start
- crazy base timing #'s
- Trubokitty.com MS3X build for 99-00 w/VVT
- Is this really knock???
- High fuel consumption
- AFR/VE Table load maximums?
- Unusual Westfield MS3 Pro Setup Questions
- DIYPNP Fan control
- High idle for just short time on startup
- 1.6 Mega Squirt
- DIYPNP starts then stalls when warm
- ms2 extra enhanced labs
- 2000 MS DIYPNP Build
- Shadow Dash MS messing up your ECU settings?
- Rich swing on deceleration
- MicroSquirt for '96 FMII
- MS3X Build with no RPM and doesnt read the crank sensor
- Dead TIP120 or problem on the board?
- DIYPNP has intermittent RPM, no start
- DIYPNP Case screw size
- MS3PNPPro-I am a dumb person.
- rev MS2 - No fuel pump unless jumping GND+F/P
- MS3x idles good then random cut
- Odd surge/cutout on highway-afr spikes lean
- DIYPNP Has no RPM sync
- Rev built MS3X cranks, but doesn't start
- DIYPNP '96 1.8 - Intermittently running lean
- In need of a tune for ms2 pnp
- Stock 96 Na Diypnp Base Map
- GM IAT not reading: 04 MSM, Rev MS2E
- New MSPNP Pro and idle valve issues
- [HELP?]DIY MS2 - Last checks before dropping it in the car
- IAT sensor understanding and tuning question
- New MS3X Build and install - Car runs very rough and wont idle unless I give it gas
- megasquirt tuning question
- MS3 1.5 Engine States Alpha-N
- Thermoswitch removal
- Rough few minutes after sitting
- Need Help with MSPNP Gen 1.
- Another AEM Uego and Megasquirt thread
- Baro Reading Low
- DIYPNP Power Supply
- NB2 DIYBOB wiring
- connecting to Megasquirt over Wifi
- I want to learn
- New MS3 Install - Starts then dies, with log and msq
- MS3x no leds
- High voltage on NB1 alt output, new megasquirt install
- Has anyone heard from Reverant? MS2E firmware frustration
- Retard timing via ECU vs CAS
- ms2 enhanced, color wire quiz
- JimStim 1.5 DIY wont power up
- EV14 Injector Questions
- MS3X Firmware Update Error
- just got '05 MSM. Bought MSproPNP off ebay. how to check if it works ?
- Cheap push-in GM IAT
- Preferred Method of EBC Tuning MS3 1.4.1
- Problems with 2nd hand ms2 enhanced eco
- Shorting out help!!!
- help with tune
- Vtps
- Idle problems
- EBC connction to Braineack MS3x
- Building Ms2 DIY, having problems
- Iat sensor problem
- Multiple Fuel VE table questions.
- Mega squirt MAF delete Closed AIT sensor?
- MS2 or DIYPNP
- 01 VVT Turbo build
- Can I use a MS2 Enhanced 04-05MSM in my 1997 1.8?
- MS3 Diy parts selection
- 92 MS3X with erratic TPS when engine is running
- Track time per tank?
- v1.5 upgrade error on Rev MS3 Basic
- first start up question
- MS2 Tuning Help! Wont idle, hard cold start, tach, fuel pump runs all time time.
- Sequential Ignition on ms2 pnp with custom Toyota cops???
- Hesitation on a cold engine
- Starts and then dies...
- Racepak IQ3s How-To
- Stumbles During Warmup
- MLV Data Log File General Housekeeping
- DIYPNP Parallel Installation On A Previously Automatic Car?
- 1999 DIYPNP IDLE VALVE ISSUE
- poormxdad's consolidated tuning shenanigans thread
- Acceleration measurement datalog
- TunerStudio not recieving AFR signal
- What is going on with my AFR
- Megasquirt Orlando Fl
- Now shipping: the MS3Pro Ultimate!
- 96-97 MSPNP2 rewire for 95?
- Another MS3 Basic Firmware Update Thread
- Rev ms3 no controller found/no com
- Needed to increase VE table by 30 everywhere
- NB 05 ignition system on DIYPNP